Atlas Engineering Ahmedabad, Gujarat

1.Each compartment is equipped with mechanical overflow chute and sampling pods. 2.Mineral temperature sensors are located inside the sand compartment. 3.Oversize material will flow out via overflow chute to a collection point. 4.Each compartment is equipped with a pneumatically actuated two-stage discharge gates controlled by the computer system. 5.Each compartment has a maximum level indicator that is wired remotely to the control room to warn operator when bins are full.

1.Designed to weigh up to 4 different aggregates. 2.Weigher is fitted with proper shock proof device to prevent the transmission of vibrations to the load cells. 3.Discharge of the weigher is through two discharge gates that operated pneumatically.

1.Designed to weigh up to 3 different sources. 2.Sealed with neoprene, which is heat resistant in the temperature range of -40 to 150 C. 3.Butterfly valves cw high torque pneumatic actuator, solenoid valves & micro switches

1.Designed to weigh up to 3 different sources. 2.Bitumen is circulated from storage tank through 2-way valve, actuated by compressed air. 3.Weigher tank is insulated with Rockwool slabs and heated at the base by thermal oil. 4.Weigher is provided with overfilling protection. 5.Mechanical dial thermometer indicates the bitumen temperature in the tank. 6.Gravity discharge to bitumen spray pipe.

1.No compressed air is required. 2.Low-reverse air cleaning principle using pressure difference between the vacuum pressure of the exhaust gases and the reverse-air pressure. 3.High corrosion resistant steel is insulated at the top with 50mm Rockwool slab and cladding. 4.Filter bag cages in corrosion-resistant aluminum. 5.Radial vane damper with electrical servo-motor actuated cw remote operation and automatic drum suction regulator. 6.Exhaust fan is mounted on filter outlet. 7.Sand separator unit at the inlet to screen off the coarse filler to protect the filter bags.

1.Directly below the filter unit cw dosing screw conveyor to the filler weigher. 2.Caged ladder access and flat form for level indicator and screw conveyor. 3.Level indicator to monitor the filler content. 4.Excess filler discharge flap and piping.