We have started a new training batch on NX 8 on Fixed and Multi Axis Techniques Course. Following are the course contents:
* Introduction
* Principles of multi-axis machining
* Important considerations
* Plunge Milling
* Z-Level Milling, Steep Angle, Gap Machining
* High Speed Machining, Mixed cut directions, Trochoidal cut pattern
* Fixed axis countour milling, Text drive methods, various drive methods,
* IPW and blank sensitive finishing cutting parameters
* 4-Axis Machining, main and local MCS concepts
* 5-Axis Machining
* 5-Axis Z-level Machining, variable axis Z-level machining, multi axis tilt options
* Optimized cut levels
* Multi-axis Sequential Mill Concepts, options, sub-operations, parameters etc,
* Check surfaces
* Sequential Mill Advanced, tool axis control, 3 Axis, 4 axis and 5 axis Dialog Box Method Options
* Comparison of variable contour and 5 Axis sequential mill tool axis control
* Standard and Nested Loops
* Variable Axis Contour Milling
* Project Vectors, interpolate and vector concepts
* Interpolated tool axis
* Comparing Variable contour and Sequential Milling
* Profiling Walls with Variable Tool Axis
* Auxiliary Floor and Automatic Auxiliary Floor
* Turbomachinery Milling
* Multi-blade geometry and milling
* Multi-blade hub finish machining
* Multi-blade Blend finish machining
* Non Cutting Moves
* WAVE Geometry Linking in Machining
* Refixturing and the use of IPW
* Hole Milling Operations
* Thread Milling Operations
* Generic Motion and Probing Operations
* Activities and Review