We are ranked amidst the chief Laboratory Water Baths, Suppliers in India. Our Laboratory Water Baths are accurately designed and fabricated to impart higher working efficiency. The Laboratory Water Baths are available in a wide range and at competitive prices for the clients. Construction All Baths are single/double walled in construction. In case of double walled Baths, the outer wall is made of Mild Steel Sheet and the Inner wall is made of suitably thick Stainless Steel Sheet of 304 quality. The Baths are painted in an attractive stove enamel spray paint. (SS exteriors are also provided as per requirements.) Insulation Insulation is provided in all the double walled Baths to prevent any undesired loss of temperature inside the Baths. 2" thick glasswool insulation is provided in case of High Temperature Baths and 3" thick glasswool insulation, in combination with Low Temperature protection Kenee Foam, is provided in all Low Temperature Baths. Heating & Cooling Heating is provided through long lasting sealed heaters supported on refractory bases / immersion type heater fixed at the bottom of the working chambers. A hermetically sealed compressor, coupled with an evaporation coil and fan cooled condenser, assembled in an easily serviceable tray at the bottom provides the cooling for below ambient temperatures. Temperatures The temperature ranges from above ambient to 100^oC in all heated baths but extends to 250^oC in case of Oil Baths. In the Low Temperature Baths, the temperature ranges from ambient to - 40^oC. Accuracy is as per table attached. Safety Water level arrangement is provided in most of the Baths to ensure the safety of the Heating/Cooling devices. Power Supply is automatically cut-off if the water level falls below the required level. Controls EGO Thermostats, Digital Indicator Cum Controller, 3 Heat Rotary Switch, Temperature Regulators, Indicating lamps etc. as per the requisites of the Bath are provided. Power All Baths are operated on 220 volts single phase AC supply.

We are ranked amidst the chief Laboratory Water Baths, Suppliers in India. Our Laboratory Water Baths are accurately designed and fabricated to impart higher working efficiency. The Laboratory Water Baths are available in a wide range and at competitive prices for the clients. Construction All Baths are single/double walled in construction. In case of double walled Baths, the outer wall is made of Mild Steel Sheet and the Inner wall is made of suitably thick Stainless Steel Sheet of 304 quality. The Baths are painted in an attractive stove enamel spray paint. (SS exteriors are also provided as per requirements.) Insulation Insulation is provided in all the double walled Baths to prevent any undesired loss of temperature inside the Baths. 2" thick glasswool insulation is provided in case of High Temperature Baths and 3" thick glasswool insulation, in combination with Low Temperature protection Kenee Foam, is provided in all Low Temperature Baths. Heating & Cooling Heating is provided through long lasting sealed heaters supported on refractory bases / immersion type heater fixed at the bottom of the working chambers. A hermetically sealed compressor, coupled with an evaporation coil and fan cooled condenser, assembled in an easily serviceable tray at the bottom provides the cooling for below ambient temperatures. Temperatures The temperature ranges from above ambient to 100^oC in all heated baths but extends to 250^oC in case of Oil Baths. In the Low Temperature Baths, the temperature ranges from ambient to - 40^oC. Accuracy is as per table attached. Safety Water level arrangement is provided in most of the Baths to ensure the safety of the Heating/Cooling devices. Power Supply is automatically cut-off if the water level falls below the required level. Controls EGO Thermostats, Digital Indicator Cum Controller, 3 Heat Rotary Switch, Temperature Regulators, Indicating lamps etc. as per the requisites of the Bath are provided. Power All Baths are operated on 220 volts single phase AC supply.