Our Products #4277673

Certain electrical loads such as motors can cause electrical systems to be very inductive, which results in very 'lagging power factor' i.e. wastage of energy. The simple solution to maintain the power factor in required range is to connect or disconnect the power factor correction capacitors. Manual switching is just impossible for rapidly fluctuating loads and hence an automatic control system is required which continuously monitors the power factor and make appropriate corrections to maintain it within the required range, With a very wide spectrum of features and prices, we have a wide range of automatic power factor controllers. This includes very high range models such as SYCON 66SS with a Smart Switching Algorithm implemented for fast power factor achievement as well as low cost models based on most common FIFO switching algorithm.

Electric motors are crucial component in virtually every industrial automation application or environment. Therefore optimizing their performance and reliability can play a major role in reducing costs and improving overall plant efficiency. Electric motors fail and about half of them fail because of overheating through overload, phase failure or insulation breakdown. There are wide ranges of motors and motor characteristics in existence, because of numerous duties for which they are used and all of them need protection. Fortunately, the more fundamental problems affecting the choice of protection are independent on the type of motor and the type of load to which it is connected. Motor characteristics must be carefully considered when applying protection. It is emphasized because it applies more to motor than other items of power system plant. Protection of motor exists in any form, a variety of designs & either packaged individually or in different combinations. The fundamental and basic aim should be permit the motor to operate up to, but not to exceed its thermal and mechanical limits for overloads and abnormal operation conditions and to provide maximum sensitivity to faults.

Earth leakage current give rise to temperature and progressive failure of insulation which leads to operating flash over. It is essential to detect earth leakage current well before they cross threshold limits and isolate the circuit. SYCON 770X Earth leakage Relay continuously detects the leakage current with the help of CBCT (Core Balance Current Transformer.) The CBCT is mounted externally. The current carrying cables (it may be 3 phase supply or 1 phase supply) are passed through the CBCT. CBCT detects the level of current and trip the device at set current & time.

Now a days in many industries, electrical loads are prone to failure due to the many situations like overload, undercurrent, voltage spikes, earth leakage, earth fault, neutral fault, single phasing, reverse phasing etc. SYCON provides solutions to many of these problems through its protection relays.

With a very wide spectrum of features and prices, we have a wide range of automatic power factor controllers. This includes very high range models such as SYCON 66SS with a Smart Switching Algorithm implemented for fast power factor achievement as well as low cost models based on most common FIFO switching algorithm.