Our Products #186588

Dual Media Filter (DMF) :
Dual Media Filter primarily used to Filter out Turbidity in the raw up to level of 50 NTU.It consists of of sand and Anthracite as Filtering Medium, Anthracite having higher dirt holding capacity is used for removing turbidity.

Activated carbon Filters (ACF) :
Activated carbon Filters consists of charcoal which is used as a media for removal of Free Residual Chlorine, Colour, Odour and Oil in small quantity.

Pressure Sand Filter (PSF) :
Fine mesh sand along with gravel of different sizes are used as the filtering Media. It is used to filter out turbidity from Raw Water up to level of 25 NTU.

Iron Removal Filter (IRF) :
Iron Removal Filter consists of Managanese Dioxide layer which works as a catalyst For converting Iron present in water as Ferrous to Ferric ion which can be easily precipitated & filtered physically.Iron removal Filter is used for removing Dissolved Iron from water.

Application :-

• Industries


• Tea Gardens


• Hospitals and Hotels


• Housing Complexes
  
  Advantages :-


• Safe potable Waters


• Minimum Maintenance Cost


• Reduction of Corrosion in Pipe Lines


• Easy Handiling.
  
  WATER TESTING KITS :For the detail Analysis of Water we have the following Water Testing Kit:
  
  


• Hardness Testing Kit


• Alkalinity Testing Kit


• Chloride Testing Kit


• Iron Testing Kit along with PH and TDS/Conductivity Meter.

SOFTENER :
Softener is used for removing Hardness salts (e.g.Ca, Mg. salts of Corbonate, Sulphate & Hydroxides) from water. It consists of lon-Exchange Resin in sodium form.When hard water passes through Softener bed, Sodium ions of Resin are exchanged with Ca and Mg ions and generate Soft water.Once the resin beds are saturated with Ca & Mg, the unit required regeneration with brine salt.


DE-ALKALISER :
It is used for reducing alkalinity of the water.Weak Acid Cation Exchange Resin can remove all Cations which are associated with alkalinity. The alkalinity gets converted to Carbonic acid which splits in the CO2 and water.The CO2 is removed by the de-gassifier.

This is following when the Alkalinity of water is higher than Hardness.

WAC + De-gasser system is usaed when the entire hardness is bicarbonate Hardness i.e. Temporary Hardness. But when Alkalinity is Lower then Hardness, then the Hardness excess of Alkalinity shall be non-Carbonate Hardness i.e. Permanent Hardness.This Hardness can not be removed by WAC resin, in that case split strem and de-gasser system is recommended.Once stream is passed through Softener where as the second stream is passed through SAC.Both streams are mixed and passed through the de-gasser.