Heat Exchanger us are as per the Client's Specifications and Drawings confirming to ASME Sect. VIII & TEMA. Stage-wise & Final Inspection of the Fabricated Equipments has been carried out by Client's own Inspection Wing or Third Party Inspection Agency deputed by them.Client gives us the Thermal Design Parameters of the Fluids on both the sides. Based on the nature of the fluids, first of all appropriate MOC is selected. Again Based on the nature of fluids appropriate type of Heat Exchanger is selected. After the initial confirmation on the above from client, thermal design is carried out on internationally reputed softwares like HTRIHTFS. The Heat Exchangers is optimized within the allowed parameters of Pressure Drop, using the allowed values of Fouling Factors, Fluid Velocity etc.

Heat Exchanger us are as per the Client's Specifications and Drawings confirming to ASME Sect. VIII & TEMA. Stage-wise & Final Inspection of the Fabricated Equipments has been carried out by Client's own Inspection Wing or Third Party Inspection Agency deputed by them.Client gives us the Thermal Design Parameters of the Fluids on both the sides. Based on the nature of the fluids, first of all appropriate MOC is selected. Again Based on the nature of fluids appropriate type of Heat Exchanger is selected. After the initial confirmation on the above from client, thermal design is carried out on internationally reputed softwares like HTRIHTFS. The Heat Exchangers is optimized within the allowed parameters of Pressure Drop, using the allowed values of Fouling Factors, Fluid Velocity etc.