Citel Delhi

• Nominal line voltage48 Vdc
• Max. DC operating voltage60 Vdc

The MJ8-POE is designed to protect sensitive data-processing equipment connected to a POE (Power over Ethernet) network from transient overvoltages.The MJ8-POE surge protector is deployed in signal network applications with data transmission speeds of 100 and 1000 Mbps.

• PV Network voltage1250 Vdc
• Max. PV operating voltage1500 Vdc

DS60VGPV51 are type 1+2 heavy duty surge protectors are designed to protect against lightning surge voltages in photovoltaic power supply network. These protectors are recommended when a direct lightning strike is possible on the installation.The DS60VGPV51 SPDs may withstand up to 12.5 kA 10350µs, it incorporates CITEL`s exclusive patented `VG technology`

• MOQ 1000 Pack
• Brand NameCITEL
• FinishingPolished
• ColorGrey
• ConditionRound
• ApplicationGas Use
• Length1-1000mm
• FeatureFine Polished
• TypeGas Detector Tubes
• Diameter20-30mm
• Thickness3-4mm, 4-5mm, 5-6mm, 6-7mm, 7-8mm, 8-9mm, 9-10mm
• Country of OriginFRANCE
• GrdaeBS, DIN
• Follow current interrupting capability> 100 A
• Insulation resistance≥10 GOhms

CITEL has developed a specific technology : GSG. These component are designed to be used on an AC network: they have an increased extinction capability and a higher current discharge capability with either a 820µs or 10350µs waveform.

• Max. shunt capacitance<0.9 pF
• Insulation resistance≥10 GOhms

The BT serie is a range of 3-electrode Gas Discharge Tubes designed by CITEL with ceramic and non-radioactive technology. This range is available without leads (contact on side electrodes: BT type) to fit in standard connectors blocks or holders. Versions with leads, radial leads (BTR version) or axial leads (BTS version) for PCB mounting.

• Nominal line voltage230 Vac
• Max. AC operating voltage L-N255 Vac
• Max. load current100 A

The DS250VG is an extreme duty Type 1+2+3 AC surge protector device designed to protect at the entrance of the electrical installation.This SPD is particularly useful in a high lightning density area where the risk of heavy surge current or even direct strike is high (eg: buildings equipped with lightning rods).The DS250VG is one-pole SPD and can be used in common mode or common and differential mode.

• Nominal line voltage150 V
• Max. DC operating voltage170 V
• Max. load current300mA

DLA surge protectors are designed to protect, against surge voltages due to lightning, terminals equipment connected to industrial buses, telecom lines or datalines.These surge protectors must be installed on symmetrical DIN rail and are available for most of the transmission lines: line voltage from 6 to 170V, bitrate up to 10 Mbits.