Chongqing Acore Filtration Co.Ltd

Chongqing, China

Turbine oil pollution control including reconcile the production control and operation control of two aspects. In the process of turbine oil production and operation of turbines, generally we use turbine oil purifier to remove solid impurities, moisture and gas. when the turbine oil purifier is working, the contaminated oil enters the heater through the inlet through the inlet of the outside air pressure, the heated oil enters the primary filter, the large particle impurities are filtered, and then the oil enters the water separator, vacuum separation device, through a special divergence device. The diffuser creates a large surface area per unit volume of oil, exposing the contaminated oil to an atmosphere of relatively low relative humidity, thereby removing water, air and gas from the oil. Evaporation of water vapor, the gas formed by the mixed gas through the tank and cooler condensed into a liquid, together into the water reservoir, the remaining gas was vacuum pumping out. Remove the oil from the oil pump into the fine filter into the fine filter impurities, that is, purification of oil, to complete a purification process, according to the amount of water, the need to cycle several times to completely remove the water. 1. Turbine oil purifier in the factory have been adjusted before the test, transported to the use of the site to check whether the parts are intact. 2. Oil filtration machine is installed stable, the oil port connected to the lower part of the fuel tank, the oil port connected to the upper part of the tank. 3. Oil purifier machine connected to the power and ground. The power distribution cabinet on the machine and the pump, vacuum pump, heater wiring should be checked to ensure that the connection is firm, reliable insulation. 4. The pump motor test start, observe whether the clockwise rotation (from the motor side face). Otherwise the power exchange phase.

Dvtp high vacuum transformer oil purification plant is to remove the oil in the water and impurities, to improve the electrical strength of oil to protect the paper in the paper insulation, but also to a certain extent, improve the physical and chemical properties of oil. Power distribution transformers are mostly installed in the open air environment, transformer insulating oil by external impurities, and air contact and the equipment itself running a higher temperature, the quality of the oil gradually deteriorated. After the deformation of the transformer insulating oil will not play the proper insulation, cooling effect. In order to prevent the safe operation caused by deterioration of oil quality is affected, the normal operation of the regular distribution of oil samples for analysis and do filtration treatment by dvtp transformer oil purification plant. The inspection cycle for chemical monitoring of the distribution of oil is specified for at least 3 years. Conventional inspection items include acid value, water-soluble acid, flash point, breakdown voltage, appearance. Our dvtp high vacuum transformer oil purification plant can improve breakdown voltage, reduce acid value, recover appearance, flash point and insulation performance by dehydration, degassing, removing contaminants, regeneration treatment, etc. At present, acore’s dvtp transformer oil filtration machine uses a advanced film dehydration and degassing technology, that is, oil go through degassing components to form a very thin oil film, and always completed in the oil film dehydration degassing, so that the water and gas in insulating oil can be removed completely.

Vcf cooking oil purifier helps you to strengthen the actual regulation of waste material oil through the source, also provide large substantial for the firmly regulated regarding waste food preparation oil, spend industrial essential oil. In addition , the particular ministry involving commerce and also industry will even by growing food market accessibility threshold, reinforce the guidance of the installing oil along with water separator to the organization. Vcf cooking oil purifier a related system with regard to control typically the cooking necessary oil, waste olive oil, it's not sufficient, the government might formulate a few laws and regulations in order to restrict designed to use waste cooking food oil to be able to profiteering crooks, give several compensation regarding such as the having an experienced caterer industry, within the interests connected with driven nicely restaurant administrators take care of often the waste acrylic from the oil-water separator together with his house.

Dvtp high vacuum transformer oil filtration plant is to remove the oil in the water and impurities, to improve the electrical strength of oil to protect the paper in the paper insulation, but also to a certain extent, improve the physical and chemical properties of oil. Power distribution transformers are mostly installed in the open air environment, transformer insulating oil by external impurities, and air contact and the equipment itself running a higher temperature, the quality of the oil gradually deteriorated. After the deformation of the transformer insulating oil will not play the proper insulation, cooling effect. In order to prevent the safe operation caused by deterioration of oil quality is affected, the normal operation of the regular distribution of oil samples for analysis and do filtration treatment by dvtp transformer oil filtration plant. The inspection cycle for chemical monitoring of the distribution of oil is specified for at least 3 years. Conventional inspection items include acid value, water-soluble acid, flash point, breakdown voltage, appearance. Our dvtp high vacuum transformer oil filtration plant can improve breakdown voltage, reduce acid value, recover appearance, flash point and insulation performance by dehydration, degassing, removing contaminants, regeneration treatment, etc. At present, acore’s dvtp transformer oil filtration machine uses a advanced film dehydration and degassing technology, that is, oil go through degassing components to form a very thin oil film, and always completed in the oil film dehydration degassing, so that the water and gas in insulating oil can be removed completely.

Vlf vacuum lube oil purifier from acore filtration co. Ltd adopt plane evaporation and the three-dimensional flashing evaporation to remove water under the negative pressure. Plane flashing uses the heating of the oil in the vacuum tank to dehydrate, which takes long dehydration time and capacity of dehydration is not good. Three-dimensional flashing technology extend the time of oil staying in vacuum tank to increase its dehydration function, but it should put a lot of reaction devices in vacuum tank , so that it reduces the volume of the vacuum tank, the more reactive devices, the less effective volume of the vacuum reaction. As we know that at certain temperature and vacuum conditions, bigger volume of vacuum tank brings better capacity of dehydration. Therefore, whatever the vlf vacuum lube oil purifier adopts two-dimensional or three-dimensional or even four-dimensional flash evaporation technology, which can not increase capacity of dehydration. vlf vacuum lube oil purifier supplied by acore filtration co., ltd use of micro-gram technology, which can completely remove moisture from hydraulic oil, gear oil, turbine oil, compressor oil, refrigeration oil, metal processing oil, gas tank sealing oil and other lubricants, this technology can greatly improve the corresponding treatment of lubricating oil after the corresponding indicators, and ensure that oil is used in high-grade machinery and equipment after filtration. Today, most of manufacturers of vacuum lube oil purifier use plane evaporation technology and three-dimensional flash technology to remove water. Not only the dehydration time is much long, but also the efficiency is bad. If the flat-flash technology can remove free water, three-dimensional flash can improve the efficiency of dehydration, and the micro-gram technology can fundamentally completely remove variety of water from oil.