Other Products / Services #3421779

CONTACTOR PANEL

VFD PANEL

125 amp current collector for dsl busbar system

WIRELESS RADIO REMOTE CONTROLRANGE : 100 MTR2 BUTTON TO 12 BUTTONTYPE : SINGLE & DOUBLE SPEED BOTH

TOUCH HMI

TheAntiCollision Device(ACD) is a self-acting microprocessor-based data communicationdevicedesigned and developed byEmbicon Tech hub for Application of Crane Anti collision system.

For Laser base EOT Crane Collision avoidance system and make crane safety. Embicon is leading manufacture of Crane spare and safety Device.

The Anti-collision system is a safety device to avoid to collision of two electric overhead traveling cranes working on the same rails. For one pair of cranes two sets of anti-collision systems are required. Each set consists of an Emitter/sensor module and a Reflector.The System works on the principle of retro-reflective infrared waves. It consists of an emitter and sensor module and a special reflector. The emitter emits the infrared waves in the direction of the reflector. The reflector reflects these infrared waves back to the sensor. The sensor senses the presence of these reflected infrared waves and activities an alarm signal and stops/reduces the speed of the cranes. Thus if the two cranes are away from each other then the reflected waves will not reach the sensor and the cranes operate normally. The sensing distance is adjustable between 3 to 10 meters. The anti collision system is specially designed for the crane application and is suitable for the continuous duty.

Laser Alignment Tool for alignment of reflector and control unit.Terminal Strip Connections:1. P Phase 220V AC CAUTION : Connect 110V / 220V AC2. P Phase 110V AC at appropriate terminals.3. N Neutral Never connect 220V AC supply4. E Earth to 110V AC terminal No. 25. NC -OUTPUT Normally closed contact6. C -OUTPUT Common7. NO -OUTPUT Normally open contact

A.C/D.C. Fail Safe Brakes are operating on A.C/D.C. Supply and used to stop motion where emergency stop is required. The Brake is normally in ON Condition ( In Braking Condition) and when D.C. Supply is given to the coil, the Armature Plate attracts towards the Brake Stator against the springs. When the supply is cut off, the brake will engage by means of spring pressure.

Brake Liner for thruster Brake and EM Brake

Embicon Tech Hub offers C Rail Festoon System that is used for electrical or energy transmission in EOT Cranes, Jib Cranes, Gantry cranes, Electric hoists, transfer car, transfer trolleys and various type of material handling equipment and moving machinery.

The offered C rail festoon systems are manufactured using the finest quality raw material and modern technology from Giovenzana International. Moreover, we offer these C rail festoon systems to our patrons after make sure that our offered C rail festoon system is of the best in quality in the market.

Special features of our Festoon system:

Precision-designed

Higher load capacity

Excellent performance

Longer service life

Supplied in ready-to-install condition

Simple to install

Suitable for Short span and long span

Suitable for medium and fast travel speed

Replaceable in place of wire rope festoon system and I-beam cable trolley system

Quick delivery.

Components for Festoon system:

C-Rail bar (Galvanized steel, Load capacity: 100kg/meter)

C-Track Coupler with screws

Hanger Clamp with bolt(to weld with support bracket L type)

End Stop (Material: PA 6)

End clamp with Stationary trolley (Material: PA 6 and galvanized steel)

Towing Trolley

Steel Cable trolley (with steel rollers and ball bearings) suitable for Round and Flat cable.

On request:Plastic cable trolleys(Type of Roller: PA steel rollers).On request:Bolted typeFestoon system with components is also offered.