Encon Group has the requisite expertise and capabilities in developing the creative, economical solutions of furnaces required for heat treatment of pipes, rods and bars. These furnaces can be either Batch or Continuous Roller hearth types with or without protective atmosphere. The Emerging Energy Efficient Furnace Builder & combustion solutions provider. Furnace Types Furnace for Normalizing ( Recrystallising and Stress Relieving) Furnace for Spherodising, Soft Annealing Furnace for Solution Annealing, Hardening, Quenching & Tempering. Furnace for the bright annealing of refrigerator tubes and braking system pipes Advantages High Capacity and easy adaptation of conveyor systems to annealing process Gas- tight Furnace suitably designed for protective atmospheres. Low Maintenance requirements High Furnace availability Extremely versatile in application Configuration A charging table for charge preparation, A cross conveyor, to transfer the charge to the inlet roller table of the furnace. A furnace seal system for effective separation of the furnace atmosphere from the ambient air, the direct-fired or indirect-fired furnace with downstream cooling section. A seal system at the cooling section outlet An outlet roller table with discharging system Features Single ended Radiant Tube Burners compared to U-type Burners Individual Ignition Control of every burner Burner control in On-Off – Round Robin mode versus continuous control. State of Art PLC and PC - System for Furnace Control Special selected Refractory Inlet Table width increases from Inlet Table to Furnace, to Cooling Section to Outlet Table Separate Cooling water controls for Cooling section walls, roof and waterbox Sufficient Cross Transfer Table and Roller Spacing to always support tubes Gear with special transmission ratio allowing even hand movement of furnace roller Nitrogen supply at Inlet Outlet to put out possible fire