Ferrotherm Engineering Pvt Ltd

Changodar, Ahmedabad, Gujarat

We are offering galvanizing plant. Complete setup of hot dip galvanizing plant. Design, supply and installation of pulse fired high velocity furnace consisting of high velocity burners (imported from uk), fuel trains with safety controls, pressure regulators, fuel ratio mixers, control valves, flow meters, supply pumps, air fans, thermocouples, insulation etc. we undertake complete project management that includes - plant design and layout - project consultancy - prepare feasibility report - assist in bank financing - supply of furnace and allied equipment - supply of pickling tanks - supply of pollution control devices such as fume enclosure, fume extraction system. • supply of ancillary tools like dross grab, shovel, skimming tools, jigs, loading stands etc • efficient material handling systems we provide assistance 24x7 to our clients.

• Surface TreatmentCoating with Zinc
• FunctionGalvanizing
• After-Sales Service ProvidedYes. 24x7
• Country of OriginIndia
• Galvanized TechniqueHot Dip in moltn zinc

We offer galvanizing furnace. Ferrotherm designs galvanizing furnaces with ‘high velocity burners’ that have long lasting proven performance on delivering high production volumes, low fuel & zinc consumption, high kettle life and requiring less maintenance. The furnace could be designed as dual fuel, oil only or for gas only as fuel. The furnace contains full control trains mainly equipped with controls, safety solenoid valves, piping & fittings imported from uk, germany, hungary and italy.

Ferrotherm designs hot dip galvanizing furnaces with high velocity burners that have long lasting proven performance on delivering high production volumes, low fuel & zinc consumption, high kettle life and requiring less maintenance. The furnace could be designed as dual fuel, oil only or for gas only as fuel. The furnace uses pulse fired high velocity burners that fire high-off or high-low to control temperature input. Burners are at or near their maximum firing rates when on. Therefore, they yield the highest possible convective heat transfer, which continuously moves the products of combustion through the entire furnace resulting in excellent temperature uniformity.

We are offering re-circulating preheat air drier. The re-circulating drier uses hot air generated out of the waste exhaust gases emitted from the furnace. The hot air is circulated at a very high speed to drier the steel parts before dipping in molten zinc.

We are offering flux heating system. The flux is heating using a well designed heat exchanger that receives hot water from the quench tank and heats up the flux to the desired temperature. the system could be designed and supplied using pdfe tubes (imported from netherlands) or using ss316l tubes.

Ferrotherm shall transfer the benefit of it extensive knowledge and experience to build up a plant from ground up. We can do the entire project management of the plant right from its design to commissioning. Our most experience staff shall be deployed to coordinate and monitor all the activities, suppliers, contractors and other related agencies.