Mumbai, Maharashtra, India
Our Products
ECTFE coated carbon steel equipment for 96% sulphuric acid (H2SO4) application used by wet sulphuric acid plant based in Indonesia for a renowned pulp & paper mill. Inside partition plate has to be designed properly in order to take care of the hydrostatic load when filled partially.
800 micron coating of good quality works very well for this application with average service life of 8- 10 years.
| TFM + FRP REACTION VESSEL USED BY SURFACTANT INDUSTRY FOR THE REPLACEMENT OF DUPLEX STEEL WITH M-PTFE. M-PTFE PROVIDES GOOD WELDAIBILITY WITH CORROSION RESISTANCE. POLYPLAST IS THE FIRST COMPANY IN INDIA TO MADE SUCH A BIG REACTION VESSEL IN M-PTFE. THE REACTION CONTENTS ARE PURGED WITH STEAM AT 150C, THE ACTUAL WORKING TEMPERATURE IS CLOSE TO 110C. |
2.3 mm ECTFE lined with FRP using Derakane 470-300 Momentum resin used for manufacturing ducting connected to SO2 quench tower working at high temperature of 120 Degree Centigrade. SO2 gas at high temperature is quiet corrosive & ECTFE is highly resistant for this application.
Diameter of ducting : 1500 mm , total length : 60 meters & 900 mm diameter with 20 m length
2 mm FEP lining on Mild steel equipment of 150 KL. The size of the equipment is 4200 mm Diameter x 11, 200 mm height. Other equipments were of 3000 mm Diameter x 6266 mm height.
The equipment is used by a fluorine handling company based in Abu Dhabi. It has given satisfactory performance installed since 2002. Total FEP consumed is more than 1000 m2. It has been the single largest order for 2 mm FEP fabric backed sheets for the FEP sheet manufacturer.
PTFE LINED MS SCRUBBING TOWERS FOR A FLOURINE MANUFACTURING COMPANY. FLUROINE IS EXTREMELY CORROSIVE & PTFE PROVIDES GOOD COSSOSION RESISTANCE. |
ECTFE COATED CARBON STEEL DISTRIBUTOR FOR SPRAYING 96% H2SO4 IN SO2 QUENCH TOWER. Dimensions of the ECTFE coated distributor
Diameter : 2900 mm x Height : 1000 mm
Plate on top of the distributor have number of holes which was a challenge during ECTFE coating,
we had to make sure that the complete plate with all holes are coated properly.
PVDF lined agitated Nutche Filter for a bromine manufacturing company. By lining of agitated Nutche filters by fluoro polymers we are replacing the expensive haste alloy Nutche filters.
The cost of PVDF lined mild steel Nutche Filter is 50% of haste alloy Nutche filters. We have lined more than two dozen Nutche filters & have extensive experience in executing these kind of jobs.
