These cables are designed for low loss, stable operation from the relatively low frequencies through the higher frequencies in the microwave and radar regions of the frequency spectrum. Cables may also be used as circuit elements, delay lines or impedance matching device.
These Cable are designed for low loss, stable operation from the relatively low frequencies through the higher frequencies in the microwave and radar regions of the frequency spectrum. Cables may also be used as circuit elements, delay lines or Impedance matching devices.
These sleeves are approved by LCSO Ministry of Defence as per JSS 54802:Sleeving shall be manufactured from PTFE tape spiral wrapped and fused process.PTFE Electrical Sleeving meets the performance requirements of JSS 54802BS 2848 Type 6 specification.Operating Temperature form -65C to +250CResistant to attack by lubricants, Hydraulic, Aircraft or Rocket fuel, atmospheric conditions and virtually all chemicals.
The cable possess all the unique electrical and mechanical properties of PTFE and are available in size from single wire screened or and jacketed up to cable with a maximum of 66 pairs twisted and or screened and or jacked as per required.
The tape shall be supplied on cylindrical cores having an internal diameter of 76mm.The roll diameter shall be depends on tape width and it shall be minimum 100mm and maximum 250mm.
Electrical grade RoHS complied PTFE unsintered tape is manufactured in full range of eleven colour:The tape is available in range of widths from 6.35mm(0.25") upwards and nominal thickness ranging from 0.05mm (0.002") upto and including 0.25mm ( 0.010").The tape shall be supplied on cylindrical cores having an internal diameter of 76mm.The roll diameter shall be depends on tape width and it shall be minimum 100mm and maximum 250mm.
The primary wire are PTFF insulated meeting requirements of JSS 51034 MIL-W-16878BS3G210NEMA HP3. The cable possess all the unique electrical and mechanical properties of PTFE and are available in size from single wire screened or and jacketed up to cable with a maximum of 66 pairs twisted and or screened and or jacked as per required.
SEMI-RIGID Co-axial cable are manufactured as per JSS 6145 MIL DTL - 17 H Specification. 1. Solid conductor made up of Silver plated copper clad steel (SCCS)2. Dielectric of PTFE3. Outer conductor made up of Deoxidized & annealed Electrolytic Bare or tin plated copper tubing
Standard Co-axial Cable RG196, RG187, RG188, RG400 also available in low noise version.Application of a semi conducting layer of graphite between the core and the screen enables a decrease in audio noise due to oscillation, vibration etc.
Ahmedabad, Gujarat, India
