Hebron Enterprises

Ram Nagar, Coimbatore, Tamil Nadu

C.R.I. 80 mm (3") Submersible pumpsets are built with thermoplastic impellers, diffusers and inbuilt check valve. All vital components of these pumpsets are made of corrosion resistant thermoplastic and the shaft is of SS 304410. Pumpsets are multistage centrifugal type. The optimal design of impellers and diffusers enables the best possible hydraulic efficiency.

C.R.I. Centrifugal monoblock pump’s volute chamber and impellers are designed to give the best possible hydraulic efficiency and good suction lift. Sealing is by means of a bellows mechanical seal made of carbon & ceramic is fitted over the shaft , which is ground to close tolerance. These pumps are power-driven by a totally enclosed fan cooled A.C. Induction two pole motor. Motor stator is made of low watt loss silicon steel laminations assembled under pressure and rigidly locked in the frame.

C.R.I. 100 mm (4”) Borewell Submersible pumpsets are built with impellers & diffusers made of thermo plastics and other vital components like check valve housing and suction inter connector are made of graded cast iron, outer shell made oh high quality stainless steel. The optimal design of impellers and diffusers offers best possible hydraulic efficiency. These pumps are powered by a water filled, rewindable submersible motor suitable for un-interrupted duty. The stator is wound with special water proof synthetic film insulated copper winding wires and made up of low watt loss steel laminations assembled under pressure and rigidly locked in stainless steel stator shell. Specially designed high performance thrust bearings (SS with Carbon) are used to withstand axial and down thrust loads with minimum wear and tear. Dynamically balanced rotor gives vibration free and noise free operation, thereby increases efficiency and life cycle of the motor.