Powder coating booths with multi-cyclone recovery with after filter. Booth recovery systems always given with after filters to meet pollution norms for powder emissions. roll-on-roll-off booth to save on cleaning time of the booth off booths

• Batch type ovens with motorised or pneumatically operated doors


• Continuous conveyorised ovens


• Oven heated with electric or oil fired or gas fired or duel fired heating systems depending on availability and cost considerations


• We use camel back design or re-circulating air seals to reduce heat losses from conveyor cut-outs for continuous ovens depending upon size and production of the components


• The oven is cassette type bolted construction with minimum metal contact between inside surface and outside surface. This reduces heat losses from oven surface


• Heat loads and hot air distribution are designed to reach the component temperature in designed heat up time

• Batch type pre-cleaning enclosures


• Conveyorised spray pre-treatments


• Dip type pre-treatment with hoist and PLC based transporters

We select the right type of pre-treatment based on your production, type of component and chemical process.

We design optimum tank sizes for dip process.

Equipment are designed to suit the chemicals suggested by chemical supplier.

For heating of the solutions we provide following options:

• Electric heaters


• Directly immersed oil fired or gas fired heat exchangers


• External hot water system

Selection of these systems depends upon size of the tank, availability of fuel and consideration of running costs.

• Dry type booths and wet type system


• Side draft and down draft systems


• Pressurised and non-pressurised booths


• Booths with sludge pits

We suggest the right type of paint booths, depending upon paint consumption, paint finish requirement and type of components.