Oil Removal Filter

Listing ID #1343188

We are chiefly engaged in the supplying of Oil Removal Filter all across the country. All types of Oil Removal Filter are available with us including Oil Removal Filters of Ultrafilter brand, etc. These Oil Removal Filters are designed to perform in an efficient and cost effective manner and thus these are highly demanded amidst the clients.
The Solution
The unique element has a three stage filtration effect. Oil and dirt laden compressed air flows through the filter element from inside to outside. The coarse particles of dirt and pipe scale are retained inside the pre-filter. Oil, water and the remaining fine particulate matter then pass to the main medium, a three-dimensionally layered microfibre medium which provides the next two stages of filtration.
Here, up to 99.99999% of all oil and water aerosols and dirt particles down to a size of 0.01 micron are trapped. Liquid attach to the fibre and by coalescing the oil and water aerosol, bulk liquid is formed. This in turn is carried by the air flow to the outer foam sock which has a very high surface area. Within the cellular structure of the sock, the air and water separate, the air flows from the element in the upper section, whilst the water and oil gravitate to the bottom of the element and fall into the quiet zone at the bottom of the filter housing. The oil and water are discharged by a drain without the need of any maintenance.
Legend

• Final stage
• Stainless steel support sleeve
• First stage: Pre-fillter
• Second stage: Three dimensionally layered binder-free microfiber media
• Sea

• The Housing
  • Designed for optimum flow
  • Streamlined turbulence-free air inlet/outlet
  • Superlight aluminium housing with audible warning signal and differential pressure gauge
  • Steel housings with sight glass for function and level checks and differential pressure gauge
  • Multi-element housing with pressure differential gauge
  • Plastic coated inside and out
  • Complies with ISI for operation at temperature up to 1200 Cat pressures at 16 bar and up to 400 bar DIN or BS standard thread and flange connections available on request
• The Filter Element
  • Two burst-proof stainless steel support sleeves hold the prefilter and microfibre media immovable
  • The final stage blue outer foam sock has over 94% void volume and is capable of withstanding up to 200%of quoted capacity
  • The foam sock eliminates the possibility of liquid carryover into the clean air
  • End caps are securely bonded with epoxy resin to the internal support sleeves
  • Each element has a reliable O-ring seal
  • Available in HTCR and HTNX grades for acidic, alkaline gases and for aggressive oils
  • Filter media is chemically, biologically, biochemically neutral and inert. It has 94% void volume