RRI Flow Transmitter

Listing ID #3959544

Get Latest Price

MOQ 50 Piece
Nominal widthDN 10 (RRI-010), DN 25 (RRI-025)
Materials, nonmedium- contactPVC cable, 1.4305, 1.4301, CW614N nickelled
Electrical connection Sensorcable 2 m or for round plug connector M12x1, 4-pole
Sensorinductive
Supply Type Exporter, Supplier

Preferred Buyer From : All over the world

View More Details

Send Enquiry

Product Details

Ingress protection IP 67
Nominal width DN 10 (RRI-010), DN 25 (RRI-025)
Conformity CE
Resistant to short circuits yes
Reversal polarity protected yes
Output current max. 200 mA / NAMUR max. 7 mA
Materials, nonmedium- contact PVC cable, 1.4305, 1.4301, CW614N nickelled
Medium temperature 0..60 °C
Sensor inductive
Make Honsberg
Pressure resistance PN 16 bar
Current consumption at rest 10 mA / NAMUR max. 7 mA
Electrical connection Sensor cable 2 m or for round plug connector M12x1, 4-pole

Flow Transmitter RRI :

Uncomplicated measurement of flow rates
No magnets; uses inductive sensor
Long working life thanks to high quality ceramic axis and special plastic bearing
Run-in and run-out sections are not necessary.
Modular construction with various connection systems
Plug-in and rotatable connections
Output signal PNP or NPN
Intrinsically safe behaviour
Optionally, non-return valve, filter, constant flow rate device in the connections.

Characteristics : The flow meter consists of a spinner which is rotated by the flowing medium. The rotor's rotational speed is proportional to the flow volume per unit time. The rotor is fitted with stainless steel clamps (optionally titanium or Hastelloy. An inductive proximity switch records the rotational speed, which is proportional to the flow rate.

Wiring : the valve should be installed behind the sensor. A running up time of approx. 0.5 seconds and a running down time of approx. 3 seconds should be noted.
Handling and operation
The Rototron device is installed in the pipework with the aid of the rotatable adapter pieces. If necessary, the adapters can be removed from the body of the housing after the stainless steel clips have been removed from the housing. Before reinstalling, it should be ensured that both the adapter with the O-ring and the sealing surface in the body are clean and undamaged. The adapters should be fitted carefully in the housing (it is best to turn them), so that the O-ring is not damaged. With this flow sensor, there is no need for run-in and run-out sections. However, it should be ensured that the flow sensor is at all times filled with medium. Any preferred installation position is possible, but the best possible venting position should be chosen (rotor axis horizontal, flow horizontal or from bottom to top). Air bubbles affect the measurement results. For filling processes
Options : Rotor with titanium clamps
Accessories :

Cable/round plug connector (KB...) see additional information “Accessories”
Evaluation electronics OMNI-TA
Mechanical connection pieces with non-return valve, filter, constant flow device or customer-specific requirements available on request