Grade 5.6, 6.8, 8.8, 9.8, 10.9, 12.9
Thread Size (mm) : M8 X 1 to M28 X 3
Length of the Bolt : 40 mm to 700 mm

Its a very critical component used in vehicles for Gear Shifting mechanism. The dimension maintained are in microns and the surface is protected from wearing out by localized Induction hardening.

We manufacture all types of Round bars shaft components as shown in the Pictures, involving all processes like turning, drilling, ID keyway, woodruff key, Heat treatment, grinding etc.

Forged components machined, induction hardened, broached, Surfaced Splined etc used at the ends of the Propeller Shafts.

We make lots of machined components from forgings like forks, hooks, thrust plate, toe hooks , brackets, pulleys, breeze nozzle, Bolster wear plate, torsion arm etc.We also make components lit Pivot Pin ( Trunion Pin) used in Boggie Suspension, sleeve injectors ( engine), Detent pin etc.

Drawing the capacity is from 7 mm to 35 mm diameter
Grinding the capacity is from 7 mm to 40 mm diameter.
All grades of material including alloy and non alloy steel can be processed.

Grade 5.6, 6.8, 8.8, 9.8, 10.9, 12.9
Thread Size (mm) : M8 X 1 to M28 X 3
Length of the Bolt : 40 mm to 700 mm

Its a very critical component used in vehicles for Gear Shifting mechanism. The dimension maintained are in microns and the surface is protected from wearing out by localized Induction hardening.

We manufacture all types of Round bars shaft components as shown in the Pictures, involving all processes like turning, drilling, ID keyway, woodruff key, Heat treatment, grinding etc.

Forged components machined, induction hardened, broached, Surfaced Splined etc used at the ends of the Propeller Shafts.

We make lots of machined components from forgings like forks, hooks, thrust plate, toe hooks , brackets, pulleys, breeze nozzle, Bolster wear plate, torsion arm etc.We also make components lit Pivot Pin ( Trunion Pin) used in Boggie Suspension, sleeve injectors ( engine), Detent pin etc.

Drawing the capacity is from 7 mm to 35 mm diameter
Grinding the capacity is from 7 mm to 40 mm diameter.
All grades of material including alloy and non alloy steel can be processed.