We offer griffon bead sealer that is specially formulated to seal small leaks at the rim and bead area of the tire at time of mounting.
it is suitable for use with radial and bias construction tires.
• designed to be applied to tire beads during the mounting process.
• ideally suited for use with new or old tires.
• no drip formula is highly viscous with an extended shelf life.
it is a spreadable sealant for sealing leaks caused by ageing or wear on the beads of truck, tractor, em and off-road tyres.
bead sealer is applied to the bead and bead seat before the tyre is inflated. When the tyre is inflated, the solid matter contained in the solution is pressed into the uneven areas in such a way that they are sealed.
how to use:
1). After the tire has been demounted, check for any damage that may render the tire unusable.
2). Using a clean brush, apply a coat of griffon bead sealer to the bead seat area of the wheel.
3). Mount the tire on the wheel and inflate to recommended air pressure. check for leaks.
4). Allow the tire to sit for about 10 - 15 minutes and recheck for leaks.
5). Close container tightly after use.
in other words,
the product is applied between the tyre bead and wheel rim then inflated to pressure, excess material which is forced out due to the bead popping out can be washed off with just water as product is totally environmentally friendly.
for multi piece wheels the product is also a very effective fitting paste due to the products lubrication properties. The product is applied between the flange and tyre bead, fit the o ring and apply the product between the o ring and flange, fit locking ring and inflate to pressure the product will seal around the bead and o ring to give a very effective seal to last until the tyre is removed. Again excess product washes off with just water.
a product of india.

We offer griffon bead sealer that is specially formulated to seal small leaks at the rim and bead area of the tire at time of mounting.
it is suitable for use with radial and bias construction tires.
• designed to be applied to tire beads during the mounting process.
• ideally suited for use with new or old tires.
• no drip formula is highly viscous with an extended shelf life.
it is a spreadable sealant for sealing leaks caused by ageing or wear on the beads of truck, tractor, em and off-road tyres.
bead sealer is applied to the bead and bead seat before the tyre is inflated. When the tyre is inflated, the solid matter contained in the solution is pressed into the uneven areas in such a way that they are sealed.
how to use:
1). After the tire has been demounted, check for any damage that may render the tire unusable.
2). Using a clean brush, apply a coat of griffon bead sealer to the bead seat area of the wheel.
3). Mount the tire on the wheel and inflate to recommended air pressure. check for leaks.
4). Allow the tire to sit for about 10 - 15 minutes and recheck for leaks.
5). Close container tightly after use.
in other words,
the product is applied between the tyre bead and wheel rim then inflated to pressure, excess material which is forced out due to the bead popping out can be washed off with just water as product is totally environmentally friendly.
for multi piece wheels the product is also a very effective fitting paste due to the products lubrication properties. The product is applied between the flange and tyre bead, fit the o ring and apply the product between the o ring and flange, fit locking ring and inflate to pressure the product will seal around the bead and o ring to give a very effective seal to last until the tyre is removed. Again excess product washes off with just water.
a product of india.