Our Products
- The unit consists of a Rib Corrugating Machine, Un-coiler, Slitter and Coiler
- Suitable for corrugating Galvanized and color coated coil of annealed sheet
MAIN MACHINE:
- Gear Box: Worm-Worm wheel with open gears
- Other parts: cast iron stand Phosphor bronze bush with cast iron block. Roll adjusting screw with hand wheel entry table Base frame etc.
UN-COILER:
- Simple shaft and screw mechanism.
- Shaft is inserted into the coil eye hole and tightened by the screws fitted on the shaft.
- After mounting the coil on the shaft, the shaft is then mounted on the bush block and rotated by the pinch roll.
SLITTER:
- Slitter head consisting of a pair of driven slitter shaft on which by combination cutter and spacer, coil is slit in required width and pieces (slits).
- Cutter made of Hc Hcr steel heat-treated and ground to close tolerance used. 16 cutters provided with machine.
- Spacer made of EN-8 / EN-9 material hardened and ground - quantity about 50 pieces
- Construction: Fabricated, stress relieved, machined bed.
- Cutter shaft rotates on two taper roller bearings, one needle roller bearing.
- Change over of cutter, spacer by opening operator side housing manually.
- Two pinch rollers are provided at front and backside of the slitting head.
COILER
- Fabricated Drum made of heavy duty plate with bush bearing and fabricated stand with hand wheel to operate manually.
Specifications: | Model: | RCM-1100 |
MAIN MACHINE | Width of Coil: | 1100 mm |
Thickness of Coil: | 0.25 to 0.60 mm | |
Shape of Rib: | As per drawing shown below | |
Feeding Speed: | 15 m / min | |
Top and Bottom Corrugating Rolls: | 380 mm diameter, solid, machined and surface hardened | |
Main Motor: | 7.5 HP | |
SLITTER | Cutter size | 160 mm O.D. x 3.5mm thickness |
Max. cuts at a time: | 4 | |
Motor for Slitter: | 5 HP | |
COILER | Drum OD x Length: | 500 x 1200 mm |
GENERAL | Net / Gross Weight: | 4700 / 5200 kgs. |
Case Dimensions: | 2.60 x 2.20 x 1.85 | |
Shipping Volume: | 10.60 m3 |