Marudhar Paints & Polymers

Boranada, Jodhpur, Rajasthan

Red oxide, Red Oxide Zinc Chromate Primer is an anticorrosive Primer most Suitable for steel surface . It is recommended on any type of Prefabricated Steel Components where protection against corrosion is very much needed such as steel structures, Tractors, heavy vehicles, bridges, storage fuel tanks above and below grounds etc. This quality conforms to Defense specification JSS- 3-47-13 & IS- 2074 and has following characteristics :- Supply Viscosity - 80 secs , min. by flow Cup No.4@ 30’C Weight Per 10 Litre - 13.8 Kgs. Approx

Polyester inks, These inks are specially suitable for printing of reverse polyester films possessing good printability, good light fatness, at varying press speeds. Good adhesive lamination characteristics thus satisfying the lamination requirement with aluminum foil, polyethylene film, paper and board for a variety of packaging application. The prints can be laminated with the usual polyurethane based two-component adhesive. - Substrate : Marudhar reverse polyester inks provides good adhesion on untreated polyester film. In case of special requirements to compound stability in-line corona pre-treatment of the respective substrate materials is recommended.

Red oxide zinc chromate primer, Red Oxide Zinc Chromate Primer is an anticorrosive Primer most Suitable for steel surface . It is recommended on any type of Prefabricated Steel Components where protection against corrosion is very much needed such as steel structures, Tractors, heavy vehicles, bridges, storage fuel tanks above and below grounds etc.

Ink reducer, The selection criterion of solvents for reducing the ink to print application viscosity is dependent upon the print process (Flexo or Gravure), press speeds and drying condition.

Synthetic enamel paints, By brush or spray after thinning with Marudhar Synthetic Thinner. The complete system is to apply- One coat Marudhar Red Oxide Zinc. Chromate Primer. One coat Marudhar Surface Grey filler. Wet sanding with Emery Paper. The above dried and smooth surface is finished with two coats of Marudhar Synthetic Enamel.