Our Products
COB Down LightPB-18-D-L-WXOB15W LED230V AC135(L)x135(W)x110(H)mmPower: 15W
|
PD-15-D-6-1X00A6x1W LED230V AC100(f)x485(H) mmPower: 8W
PA-12-D-L-WXOC3x0.1W LEDB-22/230V AC40(f)x64(H) mmPower: 0.5W
The vacuum tube is the core component of the solar water heater. Its performance is depends on the merits of the film coating technology. Our company using the new gradient coating technology produce three- target vacuum tube and it let the heat gain more than 4%. Increasing intelligent automatic cut Road equipment to ensure the pipe accurately: The reverse osmosis deionized water equipment to protect the inner tube highly clean and control the vacuum process technology to ensure the high vacuum tube collector efficiency and resistance to attenuation performance. Three target coating process, the absorption layer with unique stainless steel aluminum nitride, ultra-pure copper mirror as reflective layer.
The production of three-target vacuum tube has three major advantages:
|
Efficient absorption high absorption ratio 96%, reflectance is reduced by 65% and heat gain increased by 4% water temperature is higher, more hot water. |
Suitable model: ordinary solar energy water heater (see picture), project heater solar energy water heater (see picture) |
A grid-tie SPV system (sometimes referred as utility/grid interactive or On-Grid) is the one working in synchronization with EB grid and pushing electricity into the grid. That result in net energy drawn from the grid is reduced to an extent of solar PV energy generation. This is the simplest and most cost effective PV design for most of the sites where power is reliable and stable. Because of the very fact that these systems are tied into the grid, it follows the safety feature of disconnecting the system from the grid when grid goes down. The system does not provide backup power during a power cuts (even if the sun is shining). But for the sites with reliable grid power and the day time usage are high, this is usually logical and economically viable system choice. Additionally, the can be synchronized with DG when the load is higher than the PV generation.
| ||
This product improves the problems of traditional solar water heater as limited hot water volume, long heat time, few out water, the worse water quality. The twice heat exchange technology makes the high temperature, high efficiency and fast hot water circulation come true. | ||
The vacuum tube collector absorbs heat energy to heat the water in the storage tank, when opening the valve, cold water flow through the inlet and then to the copper coil, the hot water in the water tank do heat exchange via copper coil with the cold water, when cold water flow through the copper coil, Its temperature been raised gradually, finally the outlet water is hot water (the temperature may be 50C lower than the hot water in the water tank)The copper coil can bear the pressure of the pressure of the running water.
|
Non - pressure solar water heater
MEGAPOWER solar assists variety of Original Equipment Manufacturers (OEMs) in various ways
Bus LightPL-11-F-L-WXOA48x0.4W LED72V DC205(W)x85(H)mmPower: 25W
PL-11-B-11-L-WXOA48x0.7W LED24V DC115(W)x14(D)mmPower: 42W
Occupancy Sensor PN-11-D-L-WXOA230V AC126.7(f)x71.2(D) mm
PF-11-D-L-WXOC16x2/24x2W LED230V ACWithout Lens160/190()x150(D) mmPower: 40/60W
4 Pin CFL RetrofitPA-12-D-L-WXOD66x0.3W LED230V AC340(L)x44(W)x30(D) mmPower : 16/18W
PA-12-D-L-WXOB18x0.3W LED230V AC40(f)x140(L) mmPower : 7/9W