MOTOMAX INC

Anangpur, Faridabad, Haryana

Incorporated in 2017, MOTOMAX INC has been operating as a single window solution provider for carbon fiber moulding operations. The company is based in Faridabad (Haryana, India) and we provide standard and tailored solutions to satisfy the emerging demands of the clients.

Process: The tail of a radio-controlled helicopter that is made of CFRPrn carbon fiber reinforced polymer or carbon fiber reinforced thermoplastic is an extremely strong and light fiber-reinforced plastic that contains carbon fibers. CFRPs can be expensive to produce but are widely used in applications where high strength-to-weight ratio and stiffness (rigidity) is required such as - aerospace, automotive, superstructure of ships, sports equipment, civil engineering, and an increasing number of consumer and technical applications. We majorly use thermoset resin such as epoxy as a binding polymer; other thermoset or thermoplastic polymers we use are polyester, vinyl ester, or nylon. In addition to carbon fibers, the composite material may comprise aramid (e.g. Kevlar, Twaron), ultra-high-molecular-weight polyethylene (UHMWPE), aluminium, or glass fibers. The properties of the final CFRP product may vary depending upon the type of additives introduced to the binding matrix (resin). We use additive like silica, rubber and carbon nanotubes. Clients are free to share specific details. So, get associated with us and avail the benefits of simplified solutions.

MOTOMAX INC is a known name, involved in providing vacuum bag molding services from Faridabad (Haryana, India). With our services, we use a flexible film to enclose the part and insulate it from outside air. The material that we use is in a tube shape or a sheet of material. When a tube shaped bag is used, the complete part is enclosed within the bag. And, when sheet bagging materials is used, the edges of the vacuum bag are wrapped against the edges of the mould surface to surround the part against an air-tight mould. This way, the lower mold gets a rigid structure and the upper surface of the part is made by the flexible membrane vacuum bag. We use a reusable silicone material or an extruded polymer film as a flexible membrane. This part is sealed inside the vacuum bag and vacuum is drawn on the part (and held) during cure.
We perform these operations either at ambient or elevated temperature with ambient atmospheric pressure acting upon the vacuum bag. Besides, we use a vacuum pump draw a vacuum. Using venturi vacuum and air compressor is considered as an economical method of drawing a vacuum. The bag that we mold is made of strong rubber-coated fabric or a polymer film. With our bag molding services, we cater to ever-changing demands of the clients across composites sector. Carbon fibre fabric and fibreglass, along with resins & epoxies are the common materials that are laminated together with a vacuum bag operation. So, to schedule an appointment, ring us on the given numbers.

Resin film infusion The resin film infusion process has been identified as a cost-effective fabrication technique for producing damage tolerant textile composites. Dry textile preforms are resin impregnated, consolidated and cured in a single step eliminating costly prepreg tape manufacture and ply-by-ply layup. The large number of material properties and processing parameters that must be specified and controlled during resin infiltration and cure of textile composites make trial-and-error procedures of determining the processing cycle extremely inefficient. Analytical and numerical models are clearly far superior alternatives for determination of optimum processing cycles.