Air Plasma Cutting Machine with Air Cooled Torch

Air When Heated upto 30,000 F undergoes ionic changes & reaches the Fourth State of Matter, Called Plasma. Instead of Expensive Argon or Nitrogen, We use only Compressed air Plasma Formation. Hence its called Air Plasma.
Application :-
Air Plasma can be used to cut following metals : Mild Steel, Stainless Steel, Carbon & Alloy Steel, Aluminium & its Alloys, Copper, Casting, Bronze, Brass, Manganese Steel & Special Alloys etc.

Plasma Arc Cutting is an excellent Choice for most cutting applications but it is particularly well Suited for applications where speed and excellent cut quality are important. Because of the intense heat of the Plasma Arc - around 30,000 F compared to 5,700 F, With Gases used with Oxy-Fuel Torches - The Cut is Clean with little or no dross.
The Plasma Arc also Cuts ferrous and non-ferrous metals much faster than an Oxy-Fuel torch or abrasive saws, With low or no heat affected zone, Especially on thinner metals. A Clean cut with little or no dross means less time and money is required to finish the work piece. Parts are virtually weld-ready.

Air Plasma Cutting Machine with Air Cooled Torch

Air When Heated upto 30,000 F undergoes ionic changes & reaches the Fourth State of Matter, Called Plasma. Instead of Expensive Argon or Nitrogen, We use only Compressed air Plasma Formation. Hence its called Air Plasma.
Application :-
Air Plasma can be used to cut following metals : Mild Steel, Stainless Steel, Carbon & Alloy Steel, Aluminium & its Alloys, Copper, Casting, Bronze, Brass, Manganese Steel & Special Alloys etc.

Plasma Arc Cutting is an excellent Choice for most cutting applications but it is particularly well Suited for applications where speed and excellent cut quality are important. Because of the intense heat of the Plasma Arc - around 30,000 F compared to 5,700 F, With Gases used with Oxy-Fuel Torches - The Cut is Clean with little or no dross.
The Plasma Arc also Cuts ferrous and non-ferrous metals much faster than an Oxy-Fuel torch or abrasive saws, With low or no heat affected zone, Especially on thinner metals. A Clean cut with little or no dross means less time and money is required to finish the work piece. Parts are virtually weld-ready.