The AC Power Monitor is a solid state Power Meter. Monitoring of single phase AC supply including all types of energies. The AC Power Monitor is based on a dual micro controller , with a high degree of programmability. The Meter has been programmed to operate as an intelligent front end measuring and storing device & serial port connectivity qualifies model AC Power Meter. The Meter’s supplied preprogrammed for operation and can be directly installed. The Meter can be read manually or through a RS-485 MODBUS RTU Protocol. 
Measured Parameters:- 
1] RMS Voltage (Volt) Phase – Neutral measured. 
2] RMS Current (Amps) Phase current. 
3] Frequency. 
4] Power Factor. 
5] Active Power (KVA). 

• No Auxiliary Power Supply required.
• Good reading stability, high reliability, and good quality of load.
• LCD Display (2X16 Char) with Back Light.
• Calibration: using front keys.
• Digital Input for D4 / Mains coad selection
• Voltage separation for RS 485 (MODBUS-RTU Protocol).
• Fully User Programmable.
• CT Ratio/Gain Settable.
• All Menus are Password Protected.
• Communication with PC ginen , Separate contact for communication TX & RX

The AC Power Monitor is a solid state Power Meter. Monitoring of single phase AC supply including all types of energies. The AC Power Monitor is based on a dual micro controller , with a high degree of programmability. The Meter has been programmed to operate as an intelligent front end measuring and storing device & serial port connectivity qualifies model AC Power Meter. The Meter’s supplied preprogrammed for operation and can be directly installed. The Meter can be read manually or through a RS-485 MODBUS RTU Protocol. 
Measured Parameters:- 
1] RMS Voltage (Volt) Phase – Neutral measured. 
2] RMS Current (Amps) Phase current. 
3] Frequency. 
4] Power Factor. 
5] Active Power (KVA). 

• No Auxiliary Power Supply required.
• Good reading stability, high reliability, and good quality of load.
• LCD Display (2X16 Char) with Back Light.
• Calibration: using front keys.
• Digital Input for D4 / Mains coad selection
• Voltage separation for RS 485 (MODBUS-RTU Protocol).
• Fully User Programmable.
• CT Ratio/Gain Settable.
• All Menus are Password Protected.
• Communication with PC ginen , Separate contact for communication TX & RX