Manufacturer / Exporter / Supplier / Retailer Of Visual Fault Passage Indicator, Personnel Protective equipment, High Voltage, Surge Arrester, Hollowcore Bushings, Operating Rods, Polymeric Insulators, Insulation Enhancement System, Heat-Shrinkable Heavy-Wall Tubing, High Voltage Installation Tool ... Read More
We design, manufacture and offer a wide range of Low Voltage Distribution Feeder Pillars for various needs. Raychem’s main electrical feeder pillar comes with single and double door options with or without protection device as per the requirement. Our Feeder Pillar is highly costeffective and provides value for money to the customers.
Link boxes are used with cable joints and terminations to provide easy access to shield breaks for test purposes and to limit voltage building up on the sheath. Lightning, fault currents and switching operations can cause over voltages on the cable sheath. The link box optimizes loss management in the cable shield on cables grounded from both sides.
EHVS joint is a pre-fabricated three-piece design for voltage classes up to 170kV. Polymer insulated cables of various designs can be adopted with respect to shielding and metal sheath. Cross-section up to 250 mm2 is applicablePre-fabricated three-piece splice design, Using torque controlled conductor sleeves
The Substation Total Demand Monitor has been designed to provide an easy to install (30-45 minutes), versatile and configurable metrology system. The total demand of the substation is calculated by the summation of the feeder loads and all loading parameters are measured. The system may be configured to measure transformer output and feeders by using Rogowski coils. Busbar voltage phase to phase angles may also be measured for the 3 phases. Working in conjunction with RTU, which provides RS485 over Modbus; the data is transmitted to a central server over GPRS using DNP3NEXUS protocol. This can also be made available to other manufacturer�s host servers if required. Continual logging of metrology values is done via the Modbus interface and all logs are datetime stamped, with the clock being synchronized with central server. Alarms and alerts relating to a range of measured parameters can be sent out.
Stripping tool for extruded and bonded cable screens and primary insulation for cable diameters from 35 to 90 mm.
nsulation enhancement systems for substations and overhead lines.Designed to prevent unplanned outages due to accidental bridging and to help upgrade insulation levels at critical points in systems. We provide a wide range of LV, MV, and HV products to the world’s electrical utilities, OEM’s, industrial customers and railways. Asset protection solutions help our customers to improve system reliability and prevent costly damage to equipment caused by accidental interphase or phase to ground bridging. Bridging can occur when birds, animals, vegetation, air-bourne debris and even vandalism comes into contact with bare electrical systems in substations, overhead lines and all related equipment. By insulating strategic areas it is possible to eliminate such problems and in areas of growing environmental awareness, such as the protection of endangered species, our insulation products will allow wildlife to come and go without danger of being electrocuted.
Share your thoughts with other customers for Raychem RPG Limited
Add Review
