We are reckoned as one of the prime Manufacturers and Suppliers of Vibrating Machine in India. Also known as mold vibrator or mortar cube vibrator, the Vibrating Machine is used for the preparation of mortar cubes for the determination of compression strength of ordinary and rapid hardening Portland cement, low heat Portland cement, Portland bleast furnace cement and high alumina cements. Our Vibrating Machine features a vibrating frame assembly and an electric motor mounted on a sturdy base. The motor drives the shaft of the frame and imparts required vibrations to the mold. The vibration frequency of our machine is 12000 + -400 vibrations per minute. Further, Vibrating Machine can be availed with a set of springs, belt and belt guard.
Specifications :

• The complete frame assembly consists of a vice to hold a 7.06cm cube mold and two studs threaded at top and a hopper to feed the sample in the mold.
• The center of gravity of the assembly is brought to the center of the eccentric shaft or within a distance of 25mm below it
• Supplied complete with on 7.06cm cube mold with loose base plate, a time switch 0-60mins x 1min

We are reckoned as one of the prime Manufacturers and Suppliers of Vibrating Machine in India. Also known as mold vibrator or mortar cube vibrator, the Vibrating Machine is used for the preparation of mortar cubes for the determination of compression strength of ordinary and rapid hardening Portland cement, low heat Portland cement, Portland bleast furnace cement and high alumina cements. Our Vibrating Machine features a vibrating frame assembly and an electric motor mounted on a sturdy base. The motor drives the shaft of the frame and imparts required vibrations to the mold. The vibration frequency of our machine is 12000 + -400 vibrations per minute. Further, Vibrating Machine can be availed with a set of springs, belt and belt guard.
Specifications :

• The complete frame assembly consists of a vice to hold a 7.06cm cube mold and two studs threaded at top and a hopper to feed the sample in the mold.
• The center of gravity of the assembly is brought to the center of the eccentric shaft or within a distance of 25mm below it
• Supplied complete with on 7.06cm cube mold with loose base plate, a time switch 0-60mins x 1min