Fire Fighting & Protection #4974591

Dry Chemical is a powder composed of very small particles usually of sodium bicarbonate, potassium bicarbonate, urea-based potassium bicarbonate, or monoammonium phosphate with added particulate material supplemented by special treatment to provide resistance to packing, resistance to moisture absorption (caking) and the proper flow capabilities

[fire Extinguishing Mechanisms] :

• Interruption of the chain reaction sequence.
• Heat absorption effects

Multipurpose Dry Chemical is usually monoammonium phosphate-based and is effective on fires in ordinary combustibles, such as wood or paper, as well as on fires in flammable liquids, etc    

Characteristics

• Best applicable to fire extinguishing systems for protection of dangerous and associate articles which involve serious hazard and the danger of quick spread of fire.
• Easy to clean arter application of Dry chemicals Economical as they are less contaminative.
• Excellent insulation permits application of Dry chemicals to high-tension electric installation such as a transformer.
• Handling of Control Valve is simple and plain ensuring easy cleaning of piping after use

Total Flooding System

• A total flooding system means a supply of dry chemical permanently connected to fixed piping, wiht fixed nozzles arranged to discharge dry chemical into an enclosed space or enclosure about the hazard.
• This type of system shall be used only where there is a permanent enclosure about the hazard that is adequate to enable the required concentration to be built up.
• The leakage of dry chemical from the protected space shall be minimized since the effectiveness of the flooding system depends upon obtaining an extinguishing concentration of dry chemical.
• In total flooding system, the rate of application shall be such that the design concentration in all parts of the enclosure shall be obtained within 30 seconds.

Local Application System

Local application system shall be used for the extinguishment of fires in flammable or combustible liquids, gases, and shallow solids such as paint deposits, where the hazard is not enclosed or where the enclosure does not conform to the requirements for total flooding. Application of dry chemical shall be from nozzles mounted on the tank side or overhead.

Area MethodApplicable to superficial fire, and the amount of extinguishing agent depends upon the hazardous area.

Volume MethodApplicable to cubical fire, and the amount of extinguishing agent depends upon the volume of the object in danger.
The hazard shall include all areas that are or may become coated by combustible or flammable liquids or shallow solid coatings, such as areas subject to spillage, leakage, dripping, splashing, or condensation, and all associated materials or equipment such as freshly coated stock, drainboards, hoods, ducts, etc. that might extend fire outside or lead fire into the protected area.

Our company is one of the foremost Service Provider of Fire Sprinkler System, which is also known as Water Monitoring system for fire fighting. It provides a complete solution against intense fires and highly demanded for its hassle free performance. The offered system is made by using the finest quality components and sophisticated techniques, under the directions of our team of diligent professionals. Moreover, we are offering the Fire Sprinkler System in various specifications at nominal rates.

Water sprinklers provide an automatic spray dedicated to the area of fire outbreak

• Sprinkler heads have temperature sensitive elements that respond immediately to heat
• A rapid response which reduces and isolates fire damage, sprinklers use less water to control a fire than the firefighting service, therefore preventing further damage from excess water.

Installation Criteria

• Pipe materials - Copper tube (BS EN 1057) - Post-chlorinated polyvinylchloride (CPVC)
• System -mains supplied, wet.
• Pipe sizes - 25 mm minimum
• Sprinkler head spacing - area covered by one head, maximum 12 m2 .
• Maximum distance between heads 4 m.
• Maximum distance from wall to ceiling mounted head 2 m.
• Operating pressure - Minimum 0.5 bar (50 kPa).

Other Details :Helps to determine the water demand accurately, by using the latest licensed hydraulic calculation software’s.

Fire NOC consultation service/ Consultancy & Licensing of fire fighting system

Under the Maharashtra Fire Prevention & Life Safety Measures Act-2006, adhering to National Building Code of India, 2005, We provide or consult following services too.

• We get  Licensing with Respective Fire Dept : Industrial Fire Noc
• Provisional Fire No Objection Certificate
• Part Final No Objection Certificate
• Final No Objection Certificate
• Renewal of Final No Objection Certificate: Building Fire Noc
• Fire Provisional No Objection Certificate
• Revised Fire Provisional No Objection Certificate
• Final Fire No Objection Certificate

We also issue : Form A & Form B

• A certificate regarding the compliance of the fire prevention and life safety measures in a building or a part thereof as required by or under the provisions of the Act, to be issued by a Licensed Agency, shall be in “Form – A”.

• A certificate which is to be issued by a Licensed Agency twice a year in the months of January and July regarding the maintenance of fire prevention and life safety measures in a building or premises being in good repair and efficient condition as specified in sub-section (1) of section 3 of the Act.