Heating coils for fluid bed driers - ready to use heating coils for fluid bed driers of capacities of 60 kgshr, 100 kgshr, 120 kgshr, 180 kgshr, 200 kgshr. suitable for steam or thermic fluid oil heating. Ideal for conversions from electrically operated driers to steam heated or oil heated models.

Air heater blower unit - capacities-500 cfm to 50000 cfm of air flowair pressure-25 mm wg to 1000 mm wg, air temp. 50 deg.c to 200 deg.cheat source-steam, thermic fluid oil, hot water or electricityblowers-centrifugal type blowers, with impellor statically & dynamically balanced.Most ideal for continuous air at given pressure, purity & temperature

Atmospheric type & forced heating type.Capacities-1 ton to 1000 tonsideal for argon, oxygen, nitrogen, carbon dioxide, & other cryognic gases.

Heating coil for standard tray driers - ready to use heating coils driers of capacities 48 trays, 96 trays, 192 trays & 384 180 trays. Suitable for steam or thermic fluid oil heating.

Air Cooled Heat exchangers are used for cooling of Water, Oil or other fluids using air as the cooling media. This can replace the conventional cooling towers, which uses water as the cooling media. As this heat exchanger use the atmospheric air, there is no consumption of water. This type of Coolers is ideal for areas where water is costly and not available in large quantity for the Industrial use.

Air coolers, condensors - with chilled water, brine solution, cooling tower water.Capacities-1 ton to 1000 tons

Company makes use of various types of Finned Tubes in the manufacture of Heat Exchangers, Heating & cooling coils. Spiral wound Crimped type, L base, G type; Integral, Wire Wound & Extruded type are some of the categories of Finned tubes. Selection of the type of Finned tubes depends on the Duty condition, Temperature & Pressure of the fluids. Material for the tubes are Carbon steel, Stainless steel, Copper, Brass. Fin material will be MS, SS, Copper, Brass or Aluminium.

Convection heatersspace heaters choice of heat sources, steam, thermic fluid oil, hot water or electricity.

Capacities-oil flow rate 25 lpm to 5000 lpmideal for cooling of the oil with atmospheric air.Cooling in accordance with dry bulb temp. Of the region. Widely used where water is not available for cooling purpose.