Post Buy Requirement
ST
Delhi, India
Verified Add Review

Other Products / Services #349667

3 Phase Servo Voltage Stablizer

Servo Voltage Stabilizer is commonly observed that, AC main supply is never 230 Volt or 415 Volt, but varies from 150 Volt - 300 volt and 300 Volt - 500 Volt. The difficulties caused by them are well known, such as Over Load Condition, Line Losses, Poor Power Factor and several other reasons. The three phase servo voltage stabilizer helps in constant voltage which is required to load is never constant, but in fluctuation manner. It is observed that during the daytime, the voltage is quiet low and during the night the Voltage is high then the normal.

S.No. Parameter Single PhaseUnit Three Phase Unit
1 Rating 2 KVA to 50 KVA 6 KVA to 2000 KVA
2 Input Voltage Range a) 180V - 280V
b) 160V - 280V
c) 140V - 280V
a) 350V - 470V
b) 340V - 470V
c) 320V - 470V
d) 300V - 480V
e) 270V - 480V
f) 240V - 480V
3 Nominal Output Voltage 230V 400V
4 Output Voltage Accuracy ± 1% ± 1%
5 LineFrequency Variation 47Hz-53Hz 47Hz-53Hz
6 Effect of Power Factor None None
7 Wave Form Distortion None added None added
8 Control Digital/Analogue Digital/Analogue
9 Response Time 10 ms. 10m s.
10 Voltage Correction Rate
1. Air Cooled
2 Oil Cooled
25V / Sec.
15V/ Sec
40V / Sec
25V / Sec.
11 LCD Display (20 x 2 matrix) Date & Time, Input Voltage, Output Voltage & Current
12 Log book Memory (Non-volatile)
  • No. of Hrs. of operation on mains.
  • Peak Current demand.
  • Nos. of Abnormal High Voltage cut-off events.
  • Nos. of Abnormal Low Voltage cut-off events.
  • No. of Hrs. of operation on DG.
13 Programmable Features(Through 2-parallel way resettable passwords) HV cut-off set
.LV cut-off set.
O/L trip set
.Time delay set
Operating mode (auto/manual)
14 Cooling:
1. Air Cooled
2. Oil Cooled
2 KVA to 40 KVA & above
5 KVA to 1000 KVA & above
15 Efficiency 97%
16 Protection a) Automatic Switch-Off against:
· Under / Over-Voltage
· Over-Load & Short - Circuit
· Single Phasing
17 Surge Protection Class C Type Secondary surge Protection





















View Complete Details

LINEAR SERVO STABILIZER

  • Capacity 100 KVA TO 2000 KVA
  • Type Suitable for Balanced Load & Balanced Supply
  • Application Indoor / Outdoor Type (Optional)
  • Phase 3 Phase, 4 Wires
  • Frequency 50Hz.
  • Input Voltage 300-460V, 340-460V, 360-460V (Phase to Phase)
  • Output Voltage 400V /415V ±1% (Phase to Phase)
  • Response Time Fraction of Second
  • Speed of Correction 8-16V/Sec.
  • Mode of Operation Automatic/Manual/Hand Control
  • Suitability Suitable for all Power Factors
  • Wave Form Distortion Nil
  • Duty Cycle 100% Continuous
  • Efficiency 98%
  • Cooling ONAN (Oil Natural Air Natural)
  • IS Standard IS : 2026
  • Transformer Oil IS : 335
  • Operating Temperature 0° C to 50° C above ambient
  • Lamination Used CRGO Lamination – M4 Grade
  • Copper Used 99.9% Pure Electrolytic Grade
  • Carbon Rollers Used High Grade Graphite Rollers
LT Automatic Voltage Stabilizers holds potential for units having either LT supply or low capacity HT connection. The range of Input supply for which the stabilizer is designed depends upon the voltage condition at the supply point.
View Complete Details

Amf Panel

An uninterruptible power supply (UPS) system is your bridge between mains power and your backup generators. Automatic mains failure (AMF) panels also referred to as automatic transfer switch (ATS) panels make the power switch to emergency standby generators in the event of a significant loss of mains power or total blackout. Without AMF panels, generators need to be operated manually and that can mean lost data, potential damage to electrical equipment and huge amounts of disruption.
View Complete Details

ISOLATION & ULTRA ISOLATION TRANSFORMER

  • Isolation Transformer Specifications Phase
  • Single Phase Input Voltage
  • 220 Volts Input Voltage
  • 220 Volts Transformer Ratio
  • 1:1 Power Factor
  • 0.75 Lag to lead Frequency
  • 50 Hz VI Electric strength
  • 1500 V AC for 120 sec. Insulation esistance
  • More Than 100M Ohms. Capacitance Coupling
  • 0.01 PF 100 db Common Mode attenuation
  • 100 db Class Of Insulation
Transformers also provide an extremely useful feature called isolation, which is the ability to couple one circuit to another without the use of direct wire connections. There are applications where electrical isolation is needed between two AC circuit without any transformation of voltage or current levels. In these instances, transformers called isolation transformers having 1:1 transformation ratios are used.
View Complete Details
Tell Us What are you looking for? Will call you back

Contact Us

List of Other Products by Servostar Transformer Ind. from Delhi, Delhi.
Post Buy Requirement
ST
Delhi, India
Verified Add Review

Other Products / Services #349667

3 Phase Servo Voltage Stablizer

Servo Voltage Stabilizer is commonly observed that, AC main supply is never 230 Volt or 415 Volt, but varies from 150 Volt - 300 volt and 300 Volt - 500 Volt. The difficulties caused by them are well known, such as Over Load Condition, Line Losses, Poor Power Factor and several other reasons. The three phase servo voltage stabilizer helps in constant voltage which is required to load is never constant, but in fluctuation manner. It is observed that during the daytime, the voltage is quiet low and during the night the Voltage is high then the normal.

S.No. Parameter Single PhaseUnit Three Phase Unit
1 Rating 2 KVA to 50 KVA 6 KVA to 2000 KVA
2 Input Voltage Range a) 180V - 280V
b) 160V - 280V
c) 140V - 280V
a) 350V - 470V
b) 340V - 470V
c) 320V - 470V
d) 300V - 480V
e) 270V - 480V
f) 240V - 480V
3 Nominal Output Voltage 230V 400V
4 Output Voltage Accuracy ± 1% ± 1%
5 LineFrequency Variation 47Hz-53Hz 47Hz-53Hz
6 Effect of Power Factor None None
7 Wave Form Distortion None added None added
8 Control Digital/Analogue Digital/Analogue
9 Response Time 10 ms. 10m s.
10 Voltage Correction Rate
1. Air Cooled
2 Oil Cooled
25V / Sec.
15V/ Sec
40V / Sec
25V / Sec.
11 LCD Display (20 x 2 matrix) Date & Time, Input Voltage, Output Voltage & Current
12 Log book Memory (Non-volatile)
  • No. of Hrs. of operation on mains.
  • Peak Current demand.
  • Nos. of Abnormal High Voltage cut-off events.
  • Nos. of Abnormal Low Voltage cut-off events.
  • No. of Hrs. of operation on DG.
13 Programmable Features(Through 2-parallel way resettable passwords) HV cut-off set
.LV cut-off set.
O/L trip set
.Time delay set
Operating mode (auto/manual)
14 Cooling:
1. Air Cooled
2. Oil Cooled
2 KVA to 40 KVA & above
5 KVA to 1000 KVA & above
15 Efficiency 97%
16 Protection a) Automatic Switch-Off against:
· Under / Over-Voltage
· Over-Load & Short - Circuit
· Single Phasing
17 Surge Protection Class C Type Secondary surge Protection





















View Complete Details

LINEAR SERVO STABILIZER

  • Capacity 100 KVA TO 2000 KVA
  • Type Suitable for Balanced Load & Balanced Supply
  • Application Indoor / Outdoor Type (Optional)
  • Phase 3 Phase, 4 Wires
  • Frequency 50Hz.
  • Input Voltage 300-460V, 340-460V, 360-460V (Phase to Phase)
  • Output Voltage 400V /415V ±1% (Phase to Phase)
  • Response Time Fraction of Second
  • Speed of Correction 8-16V/Sec.
  • Mode of Operation Automatic/Manual/Hand Control
  • Suitability Suitable for all Power Factors
  • Wave Form Distortion Nil
  • Duty Cycle 100% Continuous
  • Efficiency 98%
  • Cooling ONAN (Oil Natural Air Natural)
  • IS Standard IS : 2026
  • Transformer Oil IS : 335
  • Operating Temperature 0° C to 50° C above ambient
  • Lamination Used CRGO Lamination – M4 Grade
  • Copper Used 99.9% Pure Electrolytic Grade
  • Carbon Rollers Used High Grade Graphite Rollers
LT Automatic Voltage Stabilizers holds potential for units having either LT supply or low capacity HT connection. The range of Input supply for which the stabilizer is designed depends upon the voltage condition at the supply point.
View Complete Details

Amf Panel

An uninterruptible power supply (UPS) system is your bridge between mains power and your backup generators. Automatic mains failure (AMF) panels also referred to as automatic transfer switch (ATS) panels make the power switch to emergency standby generators in the event of a significant loss of mains power or total blackout. Without AMF panels, generators need to be operated manually and that can mean lost data, potential damage to electrical equipment and huge amounts of disruption.
View Complete Details

ISOLATION & ULTRA ISOLATION TRANSFORMER

  • Isolation Transformer Specifications Phase
  • Single Phase Input Voltage
  • 220 Volts Input Voltage
  • 220 Volts Transformer Ratio
  • 1:1 Power Factor
  • 0.75 Lag to lead Frequency
  • 50 Hz VI Electric strength
  • 1500 V AC for 120 sec. Insulation esistance
  • More Than 100M Ohms. Capacitance Coupling
  • 0.01 PF 100 db Common Mode attenuation
  • 100 db Class Of Insulation
Transformers also provide an extremely useful feature called isolation, which is the ability to couple one circuit to another without the use of direct wire connections. There are applications where electrical isolation is needed between two AC circuit without any transformation of voltage or current levels. In these instances, transformers called isolation transformers having 1:1 transformation ratios are used.
View Complete Details
Tell Us What are you looking for? Will call you back

Contact Us