Wirerope Hoists

Listing ID #4213735

The rope drum is made of seamless pipe machined & grooved accurately, to ensure proper seating of wire rope in a proper layer. The drum is fitted with two heavy duty Ball / Roller bearings of reputed make for smooth operation & longer life.

The rope guide is made of special close grain castings & is specially designed and accurately machined to suit the grooves of the rope drum & prevents the rope from overriding & loosening. It also operates the limit switches provided as a safety feature to limit the over hoisting & over lowering of the hook. The guide is so designed to ensure proper tensioning of the rope.

Brake, motors, gear box & Control panel are independent units and are accessible easily. The complete hoist can be easily maintained by keeping it in its installed position, thus saving on precious labour as well as down time maintenance time.

Heavy duty deep groove ball / roller bearings of reputed make i.e. FAG / NACHI or equivalent make are used on all rotating parts and are grease packed for longer bearing life.

Push-pull, Hand Geared or Motorized Trolleys are of adjustable type and fitted with ball bearings to suit recommended size of I-Beams.

Heavy duty high tensile steel forged hooks are used & fitted in such a manner that they rotate and swivel freely.

Heavy duty 3 phase AC fail safe electromagnetic disc type brakes are provided on hoisting motion held closely to sustain the full load when current supply is switched off either accidentally or intentionally. It is mounted on the rear end of the motor for easy maintenance.

: Snap action type limit switches are provided to avoid over hoisting & over lowering which is actuated by rope guide.

Is made of sheet metal covering and are provided with (A) Schneider /C&M/L&T/ Siemens make triple reversing contractors, (b) Triple pole thermal Overload relays of auto reset type is provided in power circuit, (c) Step down transformers to give 24 /110 Volts for pendant control, (d) Cartridge type fuses are provided, (e) Special single phasing preventer is provided for the safety of Electricals.

The hoist is suitable for operation on 400/440 Volts, 3 phase.

The hoist components are subjected to strict quality control procedures. And the hoist Is finally tested to 25% overload before dispatch.

A guarantee is provided for the repair and replacement of any part which proves defective in material or workmanship provided it is not tempered with technical specifications furnished below are for Class II duty HOISTS with std. 6 mtrs lift with corresponding hoisting & CT speeds as per chart. The specifications / dimensions are subject to change in case of any deviation from our standard specifications. Higher lift hoists are also available against specific order.