A.R. Thomson Group

• Temperature, max: Continuous +400FContinuous +400F (+205C) Intermittent +700F (+370C)
• Tensile Strength2,100 psi (ASTM 152
• Temperature, min-100F (-75C)

Manufactured from solid metal, Cammprofile gaskets exhibit all the desirable qualities of a solid metal gasket with the added advantages of a reduced area of contact thereby reducing the bolt stress required to make a seal. Grafoil tape is added to the sealing surface for improved sealability. Because of their ability to seal on less than perfect flange faces, Cammprofile gaskets are often chosen as a replacement to traditional double-jacketed heat exchanger gaskets.

CANFLEX® High Temp gasket material can be used in applications above 950°F (510°C) where flexible graphite fails due to the effects of the oxidizing atmosphere at these elevated temperatures. Gaskets can be manufactured from standard sheet material, as filler material for spiral wound gaskets or used as facing on Cammprofile gaskets.

Style CW is comprised of the spiral wound sealing element only. Commonly used in tongue and groove, male-female or groove to flat flange faces.

The Isocore insulating gasket is manufactured from neoprene coated glass-reinforced epoxy (NEMA grade G-10) in place of the failure prone conventional phenolic reinforcing material. Glass-reinforced epoxy (“GRE”) is many times stronger than conventional paper grade or fabrice-reinforced phenolic. The result is that the Isocore is an economical, low pressure insulating gasket that is much stronger in compression, much more resistant to stress fractures and breakage and thus, much more reliable than conventional phenolic insulating gaskets.

Pikotek Flange Insulation Kits are designed to work in conjunction with our insulating gaskets (Pikotek VCS, PGE and RC) to effect the complete electrical insulation of a flanged assembly. The Insulation Kits consist of one full-length insulating sleeve, two insulating washers and two steel washers for each of the bolts in the flange assembly. The purpose of the insulating sleeves is to electrically separate the bolts from each side of the flange, while the insulating washers provide electrical insulation for each of the nuts attached to the bolts. This method of insulation provides the user with a high-reliability solution to complete the electrical insulation of a flanged joint.

• Pressure, Max435 psi @ 120°F (49°C)
• Temperature, max:POM body / PSU tube: 212°F (100°C)

Model ESF sealing liquid monitor is designed for applications where uninterrupted seal water flow is required. Adequate seal water flow for cooling and lubrication result in water savings, energy savings, reduced maintenance, and extended life of seals. The Thomson ESF single flow meter is an excellent choice for all styles of compression packing, single mechanical seals, FLUSH-GARD™ sealing systems – for applications where gland water reduction and minimizing product dilution is essential. The sturdy modular construction and many accessories make it very flexible.

Non-abrasive: save on shaft sleeves. Non-asbestos: reduce handling cost. Non-contaminating: will not degrade product. High strength: extrusion resistant, lower wear, longer life. High heat conductivity: lower friction, longer life. Broad chemical compatibility: save on inventory costs, use one style for all applications. Reduces maintenance costs.

Non-Abrasive: long service life General service: economize on one style Non-contaminating: will not affect product Non-Asbestos: save on handling cost Reduce maintenance costs

Oversize square braid design ensures tight seal in worn or oversized stuffing boxes CarbonAflas maximizes reliability and stability in equipment Excellent chemical resistance: 0–14 pH, except strong oxidizers Carbon filament reinforcement resists extrusion in high pressure applications Spool stock convenience Maintains an effective seal in a high radial run out or bent shaft conditions (e.g. Side entry AgitatorsMixers)