Connolly Marine

The Mark 9 is made out of one piece billet 6061 T-6 aluminum. The frame is cut out as one piece so there are no welds or crimps of the spokes at the rim. Each steering wheel is made here in the U.S.A. This makes a nice custom addition to your boat! Each wheel requires an adapter for your steering system type. Diameter: 14" # of Spokes: 4 Finish: Polished Leather Color: Black Manufacturer: Lecarra

Made from 6061-T6 aluminum with a machined finish. They are approximately 2 12" diameter by 2 12" long. There is a lightly pressed in 2" diameter double sealed bearing with the inside diameter bored to 1.002" (to easily slip over your prop shaft). It’s held in the aluminum housing by a snap ring for safety. Inside the aluminum housing is a double lip cup seal to keep the water out and a grease zerk on the outside body to grease the seal. A standard size 1 34" hose fits from the rear, Also added rounded grooves to help the hose clamp bite into the housing and not slip off. With this design there will be no more prop shaft wear of bushings to replace because it rides on a bearing!

This is a six piece gasket and Teflon O-Ring set for the Berkeley Jet Pump Set includes: (1) Bearing Cap Gasket (1) Bowl Gasket (1) Suction to Intake Gasket (1) Nozzle Housing Gasket (1) Nozzle Teflon O-Ring -250 (1) Nozzle Teflon O-Ring -352

his welded steel prop puller is one of the finest prop pullers made. Will accommodate 1" and 1 - 18" Prop Shafts Just tighten onto prop, then smack the back side with your mallet hammer!

Steering Wheel Adapter for the Lecarra 9 bolt Steering Wheel CNC from 6061-T6 Billet Aluminum Only fits the Lecarra Steering Wheel Will Fit Morse, Teleflex, and Uflex steering systems with the 34" taper Comes in raw machined finish - Great if you want to powder coat, Or polished finish Two Piece Construction 9-bolt circumference: 4.035 Length: 3" Material: Billet Aluminum

Big Block Chevrolet Square Port Exhaust Manifold Gaskets HTX-900 is a composite gasket structure consisting of graphite-coated, high-temperature facing material chemically and mechanically fused to an expanded steel core. It is intended for exhaust manifold, header, collector, and EGR system gaskets, as well as other industrial sealing applications that require high strength, thermal integrity, and anti-stick performance. Port Size: 1-78" SQ. Material: HTX-900 Quantity: Sold in Pairs

9 position deluxe cavitation control handle. Used to adjust your cavitation plates Material: Aluminum & Stainless Steel Finish: Polished Quantity: sold individually

Dan Olson Block Mounted Engine Oil Cooler for the Chevrolet Big Block Mark IV Engine There is no simpler way to cool the engine oil in your Big Block Chevy! Overall Length: 19-34" Diameter: 5" Finnish: Polished Case Material: Aluminum Core Material: Copper

New chrome marine alternator. USCG Approved. 12 Volt, self-exciting one wire hook up with a negative ground. A great addition to any engine! 94 Amp

Intermediate Housing for the Dan Olson Oil Cooler Fits between the block adapter and the oil cooler. These corrode over time and need to be replaced Finish: Raw Casting ....

This is a six piece gasket and Teflon O-Ring set for the Berkeley Jet Pump Set includes: (1) Bearing Cap Gasket (1) Bowl Gasket (1) Suction to Intake Gasket (1) Nozzle Housing Gasket (1) Nozzle Teflon O-Ring -250 (1) Nozzle Teflon O-Ring -352