Vardhman Trading Company

Rajkot, Gujarat, India

High Pressure Grout Pump (140 PSI)


Based in Rajkot (India), we are the revered Supplier and Exporter of "Able" High Pressure Grout Pumps (140 PSI) that are appreciated by buyers worldwide. The High Pressure Grout Pump (140 PSI) offered by us are appropriate for epoxy and PU grouting. We source the genuine Grout pumps from certified vendors to provide our buyers with heavy-duty, reliable and long lasting grout pumping solutions. Get them from us at marginal prices.

 

"Able" High Pressure Grout Pump (140 PSI)

The Able high Pressure grout pump is designed for use in medium and large sized prestressed concrete works. It is a hand-operated diaphram unit and weights only 9 kg. It is easily handled an particularly suited for working on scaffolding or where operating space is restricted. The Pump produces a pressure of 10kg/cm2 (140 psi) and delivers 300 liters of neat cement grout per hour of pumping. The pump is so designed that all working parts are readily accessible for easy maintenance.

 

Preparation for Grouting

Flushing of metal ducts may not be necessary in most cases. Historically flusing was used to clear the ducts of foreign materials and to wet the surfaces for better groutability. Well before commencement of the actual grouting operation, all anchorage recesses (at both ends of the cable being grouted) should be mortared up with the appropriate type of grout connector threaded in place. Allow the mortar to set.

 

Grouting

For grouting with Able standard Grout Pump the pump should be placed over a bucket containing the mixed grout. While using Able high pressure grout pump its seived suction should be placed inside the grout. In either case, the suction inlet of the grout pump should be kept low inside grout. Sand Should Not Be Added.

 

Continue Pumpping with steady even strokes and keep the grout pump bucket topped up with grout and keep the grout gently agitated whilst pumping. Do not allow the level of Grout in the bucket to fall below the suction inlet of the pump. Once pumping has commenced it should be continued without ceasing until the duct concerned is full.

 

When the duct is completely full of grout allow sufficient quantity of grout to over flow from the other end to ensure no air pockets are left. Once thick grout starts flowing from the other end of the duct, plug the vent hole and continue pumping, till the pump becomes hard to operate. Close the pressure retaining grout cock on the pumping side and unscrew the coupling. The pressure retaining grout cock can be unscrewed only after the initial-set of grout, which will be about 2 1/2 to 3 hours after grouting. The grout cock should be throughly cleaned immediately after it is unscrewed to remove all grout from the inside.

 

Precautions :

  • Do not use sand in the grout mix.

  • Sleve all cement before use.

  • Keep dirt out of the ducts by plugging the open ends with paper.

  • It is necessary to grease all grout connectors, pressure retaining cocks and coupling etc. both internally and externally before use to prevent the grout from blocking them.



Additional Information:

Payment Terms : L/C, D/A, D/P

Packaging Details : As per requirement.

Delivery Time : 5-8 days after order



Looking for High Pressure Grout Pump (140 PSI)?

[+] View All Products

Search


Contact Details

Mr. Milan Mehta

Rajputpara Main Road, Opp. Jalaram Marketing, Rajkot, Gujarat - 360001, India

View Mobile No.