Post Buy Requirement
VPL Infotech & Consultants
Delhi, India
gstGST : 07AACFV6024H1Z9 Verified Add Review

Our Products

  1. Computer Cables, Adapters & Modules 18 Products available
  2. Networking Lab 5 Products available
  3. Testing Equipment 13 Products available
  4. Electric & Electronic Active Devices 24 Products available
  5. Electronic Development Boards 8 Products available
  6. Milling Machines 16 Products available
  7. Lathe Machines 5 Products available
  8. Oscilloscopes 7 Products available
  9. Others 163 Products available

Sensors

Optical Sensor

The Optical Sensor works when any objectis placed in between the Transmitter &Receiver of the sensor.
User can observe the result of +24V or GNDat the output of the screw terminals of themodule.

View Complete Details

Proximity Sensor Capacitive

The Proximity Sensor Capacitive workswhen any object comes in contact withthe sensor.
User can observe the result of +24V orGND at the output of the screw terminalsof the module.

View Complete Details

Pressure Sensor

Pressure Sensor is an analog sensorwhich works when the air pressureis given to the sensor.
User can observe the result of theAnalog output from 1V to 5V correspondingto the pressure of 0 to1MPa at the output of the screw terminals of the module.

View Complete Details

Reed Switch Sensor

The Reed Switch Sensor works whenthe magnet comes in contact with thesensor.
User can observe the result of +24V or GND at the output of thescrew terminals of the module.

View Complete Details

Throttle Position Sensor (TPS)

The Throttle Position Sensor is apotentiometer (variable resistor)which attaches to the throttle shaftand sends a voltage signal to thecomputer, telling it how far open thethrottle is. The resistance across it is about 5, 000 ohms. At idlethe voltage is about 0.7 V and wide open throttle is about 4.0 V.You can measure the voltage with ignition on and engine off, using a voltmeter.

View Complete Details

Air Temperature Sensor (IAT)

The intake air temperature sensor (IAT) tells the ECM the temperature of the air that is going into the engine. The coolerthe air, the better the performance of theengine, which is probably why you might have noticed adifference in the cars performance on a summer night ascompared to the day.

View Complete Details

MAP (Manifold Air Pressure) Sensor

The MAP sensor is a pressure sensor chipwhich puts out a voltage proportional toengine vacuum, from zero to 5 volts. Thecomputer uses the voltage to decide if thethrottle is open and how far, so it can adjustthe fuel mixture.


View Complete Details

Crankshaft Sensor (CKP)

This sensor is very similar to the camposition sensor in functionality. It is responsiblefor telling the ECM the exact locationof the crankshaft as well as the RPM (rotationsper minute) of the engine. With thisinformation the ECM knows the position of each piston in eachcylinder.

View Complete Details

Coolant Temperature Sensor (CTS)

The Coolant Temperature Sensor is a thermistor(temperature-dependent variable resistor)which screws into the thermostat housingand sends a voltage signal to the computer, telling it the coolant temperature. The resistance acrossit is about 13, 000 ohms with engine off at room temperature.


View Complete Details

Heated Oxygen Sensor

The Oxygen Sensor is a feedback device thatsenses how much oxygen is in the exhaust.The zirconium coating in the sensor producesa small voltage when exposed to depletedlevels of oxygen, so a lean exhaust which has
excess oxygen yields a signal of about 0.2 V, whereas a rich mixture (all oxygen consumed)produces over 0.7 V.

View Complete Details

Hall (Magnetic) Sensor

The Hall Sensor works when the magnet comes in contact withthe sensor.
User can observe the result of +24V or GND at the output of thescrew terminals of the module.

View Complete Details

Infra-Red Sensor

The Infra-red Sensor works when any solid object is placed inbetween the Transmitter & Receiver of the sensor.
User can observe the result of +24V or GND at the output of thescrew terminals of the module.

View Complete Details

Level Sensor

Level Sensor is an analog sensor which works when the floatlevel moves from bottom to top position.
User can observe the result of the Analog output from 5V to 0Vcorresponding to float level from down to up position at theoutput of the screw terminals of the module.

View Complete Details

Temperature Sensor

Temperature Sensor is an analogsensor which works whenthe RTD heats up.
User can observe the result ofthe Analog output from 0V to 1V corresponding to the temperatureof 0 to 100C at the output of the screw terminals of themodule.

View Complete Details
Tell Us What are you looking for? Will call you back

Contact Us

  • Vinod Peswani (VPL Infotech & Consultants)
  • 101-104, Savitri Sadan II, 15 Comm. Centre, Preet Vihar, Delhi - 110092, India
  • https://www.vplinfotech.com
  • Share us via
  • Call 08047021748