Compacting dies

Listing ID #1286295

We are offering compacting dies. Owing to our rich industry experience, we are manufacturing and exporting an exclusive range of compacting & bunching die. Which is manufactured using high grade raw material and cutting-edge technology in compliance with industry standards. Offered range is appreciated by clients for optimum quality and long service life. We offer these products up to the size of 50 mm as per the needs of the clients. In addition to this, our esteemed clients can avail these quality tested products from us at economic price.
features:
manufactured from polycrystalline diamond:
yields a good wire surface finish with excellent die life (several orders of magnitude harder than tungsten carbide).
Reduces fines and shavings generated during production due to low coefficient of friction and wear resistance.
Long die life and minimized wire breakage make for longer, uninterrupted production runs truckload after truckload.
Manufactured from tungsten carbide:
offers an economical solution for short production runs and when wire surface quality requirements are secondary to cost savings. Possesses excellent corrosive wear resistance.
blank material:
carbide, pcd
casing:
stainless and die steel.
geometry:
size ranges from 0.300 mm to over 34 mm depending on the cable size being manufactured.
Tolerance is generally plus or minus 1% of the hole diameter.
Angle range is generally 16 to 24 degrees plus or minus 2 degrees.
Bunching and stranding dies must have a well-blended profile with no sharp edges.