Other Products / Services #7695197

PRODUCT FEATURE :

• This model has dry run protection so it only starts the motor if water is present in the underground tank or sump.
• Suitable for 0.1 HP to 5.0 HP Motor, Protect motor from dry running.
• Motor ON OFF LED indication provided.
• Water Level indication provided for both tanks.
• Auto and manual mode indication provided 
• Supply voltage : 220-270 V AC,
• Relay : 40 A
• Sensing element : S.S sensor.
• 433 MHZ RF Transmitter & Receiver, 90 meter range.
• It also work if there is obstacle between the transmitter and receiver.
• ABS Body.

Warranty Service : 

• Repair or Replacement.
• 1 Automation unit. 
• 1 user manual with technical details

HOW AUTOMATIC WATER LEVEL CONTROLLER WORKS

• This model automatically switches ON and OFF Motor. When the water level of the overhead tank becomes low means water gets down from the middle sensor and water is present in the underground tank or sump, the motor gets started automatically. The tank starts filling up. when the water level reaches to the higher level, the motor automatically gets switched off.
• Auto and Manual mode switch available. In auto mode the motor starts and stops automatically. In manual mode the user can start and stop the motor by pressing the start and stop button of the controller. No
• Additional wiring is required to operate the motor manually. 
• Also Suitable for MCB Starter panel and submersible motor, see diagram above for connection.
• Fully automatic, controls from underground tank to overhead tank so no man power required. Long service Life.
• All signals passes in sensors through the AC filter circuit that improve life of sensor,
• Isolated supply provided
• Sensor fault detection provided, if sensor got failed LED start blinking.

PRODUCT FEATURE :

• 1.0.75 sq mm 90 meter copper wire for sensor.
• 100% copper and suitable for water controller sensor.
• High insulation resistance.
• Anti termite and anti rodent, for in-house purpose.
• House Wearing  purpose use.
• High Load Consumption. 

PRODUCT FEATURE :

• Suitable for single phase submersible Control Panel. 
• Suitable for 1 HP Submersible Control Panel.
• Contractor 10 Amp Provide.
• Run Capacitor 36 MFD 
• Volt and ampere meter are provided to see system.
• Overload protection by 16 A MCB Provide.
• Start and Stop Switched to see system. 
• Power Indication to see the system.
• Metal Sheet Enclosure.
• Good Looking.
• Life Long.

Warranty Service : 

• Repair or Replacement.
• 1 Starter unit 
• 1 user manual with technical details

PRODUCT FEATURE :

• Bore well Submersible Pump Turn On and Off Automatically.
• Specially designed for Submersible pumps which don't have enough water.
• Digital Display to see Remain Delay Time.
• Extra Start Features to provide Starting Cap. For 2 Sec on each startup. 5.Available for Single/Three Phase Pumps.
• Dry run Protection.
• Bypass Switch for manual on and off.
• Corrosion Free Magnetic Float Sensors (Advance Magnetic Technology) 9.Advance Microcontroller Based Product.
• Saves Water, Motor, Energy, Time.

Warranty Service :

• Repair or Replacement.
• 1 Automation unit.
• 1 user manual with technical details

HOW AUTOMATIC WATER LEVEL CONTROLLER WORKS

• This product is designed to automatic control of motor, which ensures constant reserve of water in storage tanks.
• Automatic water level controller is used to automatically fill the over head tank as and when it gets empty and monitor the water level in it.
• Automatic water level controller switches ON the motor when the water level in the overhead tank drops below prefixed low level (on point) and puts off the motor when water level rises up to prefixed high level (off point) motor also switches off when the bore well water is exhausted before filling overhead tank, This Controller uses SS Contact type Sensor to check water availability and avoid pump running dry.
• State of the art, digital technology, advanced microcontroller based products.

Useful at: Homes, Bungalows, Apartments, Commercial complexes, Hotels, School, Colleges, Hospitals, Residential Colonies and Industries.

PRODUCT FEATURE :

• 1.0.5 sq mm 90 meter copper wire for sensor.
• 100% copper and suitable for water controller sensor.
• High insulation resistance.
• Anti termite and anti rodent, for in-house purpose.

PRODUCT FEATURE :

• Easy Installation and simple maintenance services
• Operated through mobile phone from anywhere and anytime
• Protective terminal Controller
• Varied Wires and Switches with efficient valve interaction
• Visible Input and Output controllers for User Reliability
• GSM or SIM Card Connectivity with enhanced default settings
• Rapid connectivity with durable antenna
• Notifications for probable controller settings
• Manual ON and OFF settings
• Enhanced Auto and Manual operations
• Regional language options available with clear voice input
• Missed Call To Control – Motor On and Off.

Warranty Service : 

• Repair or Replacement.
• 1 Automation unit. 
• 1 user manual with technical details

HOW AUTOMATIC WATER LEVEL CONTROLLER WORKS

• GSM Based motor Control  :- In GSM based, the GSM Pump Controllers (Mobile Pump Starter) are specifically design to operate remote located submersible pumps and motors for benefit of farmers, agriculture people and industries where wireless pump and motor control required. Our GSM based mobile pump controller is manufactured with advanced micro controller technology and quality process. Yet these devices are affordable to customer.
• Mobile Operated Pump Controller. SMS or GSM Remote Pump Controller is a device which can control and monitor electric motors, agriculture pump or submersible pump sets through mobile phone. This is a GSM-based mobile operated pump controller to switch ON and OFF pump sets or an electric motor with a cell phone from a remote location. This SMS or GSM pump motor controller helps the farmer to handle agricultural pump sets easily. The farmer can set up to five schedules for automatically start and stop the pump. It also helps the farmers to save a life from snake bite in the night time, saves water, time and electricity. One SIM Card is required for its operation.

Features :

• Cheaper and effective way to protect your shop, mall, godown, showroom, etc.

• key provide for only owner control.

• Loud alarm when burglary.

PRODUCT FEATURE :

• Controls Submersible and Open well both pumps Automatically 
• Specially Design for Home, Apartment and Bungalow applications  Suitable for all type of Pumps and motors(Single/Three Phase). 
• Dry run protection for sump tank. 
• Corrosion Free Sensors (Advance Magnetic Technology). 
• Advance Microcontroller Based Product. 
• Saves Water, Motor, Energy, Time. 
• Increases Pump Set Life. 
• Avoid Seepage of roofs & walls due to overflowing tanks.  
• Bypass Switch for Manual Operation.

Warranty Service : 

• Repair or Replacement.
• 1 Automation unit. 
• 1 user manual with technical details

HOW AUTOMATIC WATER LEVEL CONTROLLER WORKS

• This product is designed to automatic control of open well as well as submersible pump, which ensures constant reserve of water in storage tanks.
• Dual Automatic water level controller is used to automatically fill the over head tank as and when it gets empty and monitor the water level in it.
• Dual Automatic water level controller switches ON the Open well pump (sump tank pump) when the water level in the overhead tank drops below prefixed low level (on point) and puts off the Open well pump (sump tank pump) when water level rises up to prefixed high level (off point) Open well pump (sump tank pump) also switches off when the sump water is exhausted before filling overhead tank, pump running dry.
• If overhead tank water level is below prefixed low level and there is no water in sump tank than open well pump will remain off and submersible pump will start and fill overhead tank until water level rises up to prefixed high level
• So this way, Dual automatic water level control will on and off both open well pump and submersible pump one by one according to water levels in tank.
• State of the art, digital technology, advanced microcontroller based products

Useful at : Homes, Bungalows, Apartments, Commercial complexes, Hotels, School, Colleges, Hospitals, Residential Colonies and Industries.

PRODUCT FEATURE :

• 1.0.5 sq mm 90 meter copper wire for sensor.
• 100% copper and suitable for water controller sensor.
• High insulation resistance.
• Anti termite and anti rodent, for in-house purpose.