Write a Review
Our Products
Leading Manufacturer, Supplier & Retailer of Bakelite Relief Threading on Lower Punch, Threading Lower Punch, Rotating Head Shaped Punches, Tungsten Carbide Lined Punches & Dies and Carbide Punches.
For tablets that are sticky in nature, a common problem is jamming of the lower punch. The main reason for this is sticking of powder on the wall of die bore resulting in jamming of the tip in the die bore. To reduce this problem we give a sharp undercut on the punch tip, acting like a scrapping blade, which cleans the die bore at every compression.
Shaped toolings have a shorter life than round toolings. One of the major reasons is that the wear & tear of the underside of the punch head results in weight variation. To avoid this we have created a rotating head tooling so the punch head can rotate just like round tooling and avoid this wear and tear, thereby giving it longer life.
In cases when corrosive material is used or for very high volume products or products which require high compression force - the punches get corroded and a die ring is formed very fast. To avoid this wear and tear and to increase the life of the tools we use a very hard metal; Tungsten Carbide in the contact areas.
Sticking is a major problem faced while manufacturing effervescent tablets. Not only does the powder stick to the punch face but it also corrodes the tooling. To minimize these problems we use Teflon tip punches as Teflon is less prone to sticking and the disc can be replaced if damaged.
Amit Karania (Adept Export)
275, Udyog Bhavan, Sonawala Rd, Goregaon (E), Mumbai, Maharashtra - 400063, India
Share us via
