Our Products
ADORN design and manufactures Goliath/Gantry Cranes in accordance with IS: 3177 & IS: 807 and as per international standards. Goliath Cranes or Semi- Goliath Cranes are manufactured in both single and double girder version.
They are essentially the same as the regular overhead cranes except that the bridge for carrying the trolley or trolleys is rigidly supported on two or more legs running on fixed rails or other runway. These legs eliminate the supporting runway and column system and connect to end trucks which run on a rail either embedded in or laid on top of the floor.
They are ideal for outdoor applications where lifting facilities are provided without the cost of a building or any supporting steelwork. They are also suited to indoor applications where existing building structures are not suitable to take overhead cranes, and where additional supporting steelwork would result in a loss of floor area.
ADORN manufactures E.O.T. and H.O.T Single Girder Overhead Travelling Crane in accordance with IS: 3177 & IS: 807 and as per international standards.
ADORN manufactures E.O.T. and H.O.T Double Girder Overhead Travelling Crane in accordance with IS: 3177 & IS: 807 and as per international standards.
ADORN manufactures Single Girder as well as Double Girder Underslung cranes that find its application where the headroom in a factory is limited or the structure does not allow any other means of supporting the crane other from the roof. Typically, Underslung cranes ranges from 1MT to 10MT, however higher capacity Underslung Cranes can also be manufactured as per clients requirement. Precise control of the up/down motion and/or travel motion can be achieved by fitting Variable Frequency Drives in the panels (optional). Control can be either through a Pendant Push Button station or a Radio Remote Control (optional).
ADORN Jib Cranes are designed & manufactured in accordance to IS: 807 & IS: 3177. They are Wall mounted or Pillar type fully floating on bearings with swivel facility up to 360. Self aligned type double roller thrust bearings take care of horizontal, vertical and radial thrust loads.
Jib cranes are available in lifting capacities ranging from 250 Kgs to 7500 Kgs and arm radius upto 5 mtrs. for the required application.
Jib arm is fabricated from heavy section I-Beam or of triangular truss construction to keep the deflection in acceptable limits. Jib arm is suitable to accommodate trolley with chain pulley block for manual travel and lifting operations or electric wire rope hoist for electric operations.