Our Products
Our product range contains a wide range of Refrigerated Air Dryers and Adsorption Dryer
Refrigerant drying cools the compressed air, whereby a large amount of the water condenses and can be separated. The compressed air is then heated so that condensation does not form on the outside of the pipe work system.
The compressed air cooling takes place, via a closed coolant system, where a refrigerant cooling agent is employed. CompAir uses environmentally friendly gasses for this. By cooling the compressed incoming air with the cooled outgoing air in the heat exchanger, the energy of the refrigerant dryer is reduced.
as dirt, oil, and water condensate.The Donaldson Ultrapac 2000 is a complete purification package including a pre-filter, after-filter, and automatic condensate drain, and is designed to produce clean, dry air to -40F/-40C and lower pressure dew points.
The Ultrapac 2000 is the ideal drying solution for compressed air flows under 60scfm @ 100psi because of its compact design and self-controlled operation. Dryer functions and preventative maintenance reminders are automatically monitored using internal micro-electronics. Since this is a heatless regenerative dryer, the only required input is a standard 115V power supply.
Superplus: The Superplus version is an energy saving upgrade to the standard Ultrapac 2000. It is ideally suited for applications requiring transient air demands or irregular use. The Superplus dryer uses a combination of adsorption and regeneration sensors
to extend the adsorption time for each desiccant tower while using a fixed regeneration time; this reduces purge air demands when conditions allow.
BENEFITS
Easy installation and setup
Less maintenance
Minimal downtime for repairs
Increased cost savings