Stadlers Corp F.z.c

Sharjah, United Arab Emirates

Gantry machine for laser and plasma cuttingHigh value guiding machine for laser and plasma cutting, ideal for combined cutting tasks.It unites the required speed for laser and plasma cutting with the robustness and longevity of an industrial machine.Dual side rack and pinion drive system (helical) via AC - servo motors and linear guides for the X- and Y - axes.

Advantages of a solid state laser compared to a CO2 laser

The laser beam is guided in a glass fiber from the resonator to the beam generation system

• No adjustment needed
• No need for gas purging of the beam path
• No maintenance of mirrors

Cutting power

• 1500 W of a fiber laser comparable to a 3000 W CO2 - Laser
• Cutting thickness 1 - 13 mm

Safety FeaturesCompletely enclosed machine housing for optimum safety for both the process and the operatorA camera enables the control of the cutting process
Economic AdvantagesLow investment costs

• Very economical entry into the world of laser cutting
• Profitable even with only temporary capacity utilisation
• Low operating costs
• Minimum cutting costs in laser quality

ZINSER 1211 - cantilever machine for oxygen and plasma cutting

The flame cutting machine ZINSER 1211 disposes of a coordinate drive, DC-permanent tacho motors and actuation by means of racks and pinions.

Electrically controlled magnetic clutches permit an easy and quick shifting of the machine manually.

The operator aisle which has an extent of the whole machine length enables a convenient access to the central control panel and to the cutting table.

The drawings to be traced can be fixed very easily on the moveable sheet steel tracing table by means of magnets.

Basic equipment of the machine - ready to cut

• Machine with cantilever right (cantilever on the left side is also available)
• Optical follower control LK110
• Three-hose machine torch with nozzles for 3 - 100 mm thickness

Options / Accessories

• Central gas supply by means of solenoid valve
• Electric torch ignition device
• Piercing device with/without fast preheating
• Motorized and capacitive torch adjustment
• Additional machine torches (max. 4)
• Plasma cutting units
• Plasma adaption connection

ZINSER 1211 / LK 110

• Machine with optical follower control LK 110.
• Tracing speed continuously adjustable 50 - 1000 mm/min(can be switched to 200 - 4000 mm/min).

Functions LK 110

• Manual control
• Coordinate switch for all 4 directions
• Line- and edge tracing
• Automatic start of cutting job
• Automatic switch-off feed and cutting oxygen if losing the line
• Automatic corner slow-down (can be switched off)
• Kerf compensation 4mm

ZINSER 1211 / LK 500 / CNC 300Machine with optical follower control LK 500 and CNC 300.
CNC 300

• 2/3-axes CNC-control
• LCD-Display
• 65 Standard shapes / free programmable contours (MDI)
• External programming