Stadlers Corp F.z.c

Sharjah, United Arab Emirates

The T-Master is a dedicated machine designed for the continuous production of weldedT and H beams, either parallel or cambered.The T-Master operates withthe web in vertical position. No tack welding isrequired, except at the leading edge, after the web has been aligned on the center of the flange.

Initially the web and the first flange are fed into the T-Master; the welding is carried out simultaneously from both sides of the web over the full length of the beam. After completion of the first flange welding the section is turned through 180 and the alignment and welding operation repeated with the second flange.

The big advantage is that the flange is straightened during the welding process, for rectify any angular distortion caused by welding.
We have several Line dimensions, the common one is for Beams2000 /2500 ( web ) and 800 / 1000 ( flange ) but we can arrive:

• up to 5000mm of Web and 2000 mm of Flange with more than 2.5 Ton /m

The length of the Beams normally is from 4/6 meters min. to12 / 18 meters max. beams; but we can arrive at 35 meters or more.The big advantage of this line is the flexibility, not a lot of space required, no flanges straightening required after welding, few workers required.

The H-Master is designed to weld I beams with the web in horizontal position. The H-Master deposits two fillet welds simultaneously at the web and flange connections. ack-welding is required only at the leading edge of the beams.

These COILS TILTERS permit the tilting of coils with a hole in the horizontal axis through 90 and vice versa. Their operation can be electro-mechanical or electro-hydraulic and they can also be fitted with various options and extremely valid safety systems according to customer requirement. The way in which these tilting devices are created depends on specific customer requests. This latter supplies all the technical information necessary for precise construction. With the aid of our qualified technical staff we analyse the situations even by visiting the installation site - to find the best solution to satisfy the most widely varying demands.

Not all coils are stored in multiple levels. Sensitive material may not be stacked due to the risk of damage. Sometimes regular coils are stored temporarily awaiting further processing and slit coils are usually too narrow for stacking.

For these applications Lankhorst Mouldings have developed a wide range of KLP Storageblocks and KLP Oiltrays. These are V-shaped floor pads that can easily be installed in any warehouse. Sometimes these coil padsare fixed to the floor, but this is not always necessary.

We offer our storage blocks in a variety of dimensions. Chock angles up to 15 allow optimal support for (slit)coils. KLP Oiltrays usually have a groove in the centre of the product. This allows the drainage of oil which may drip from the coil.