Wahat al ramz trading LLC

SHARJAH, United Arab Emirates

Class I (EN 13160-1:2003) leak detector, high vacuum based, for use with double-skinned tanks and single-skinned tanks with internal lining.The unit is designed for monitoring above ground and underground tanks containing inflammable liquids of danger class A III as well as non-inflammable, water polluting liquids and urea solutions 32, 5 % (AdBlue). Also suitable for renovating double-skinned tanks which were previously monitored with leak detection fluid.(Refer to the operating instructions for a definition of the stored media).
Eurovac 04-1 is adjusted for an alarm vacuum level of 325mbar and approved for tanks up to 2.9m whereby the suction tube connection may end at the top of the tank. If mounted outdoors, special installation requirements have to be observed, e.g. protective housing, greater internal capillary tube diameters (6 mm), condensate traps.For tanks according to EN 12285-1, EN 12285-2 design A, DIN 6618-2, 6619-1, 6623-1, 6624-1 as well as equivalent tanks made from steel or equivalent approved tanks made from plastic, provided that they have double walls or are equipped with an approved leak protection lining (internal lining) according to EN 12285-1 or by analogous application of EN 12285-1.For tanks according to DIN 6625-1 which are equipped with an approved leak protection lining (internal lining) and cylindrical, rectangular or spherical tanks made from reinforced concrete or equivalent, approved tanks made from other materials which are equipped with an approved leak protection lining (internal lining).

Not for use on tanks containing inflammable liquids (Use LAD series).

The LAD-R pressure type leak detector contains the following elements in an impact-resistant housing display elements and controls, a printed circuit board with the electronic components for processing the output signal and connections for the remote pressure gauge with two switching contacts or individual high and low pressure switches as required.

The LAD-R monitors the over/under pressure in the interstitial space of a pipe or storage tank and generates an alarm signal in the case of a pressure drop or increase.The alarm is indicated audibly and visibly and is also available via a voltage-free relay contact (1 changeover contact). The switch points for low and high pressure can be adjusted via the two switching contacts of the remote pressure gauge by means of an adjustment spanner. The total monitored interstitial space volume must not exceed 1200 litres per LAD-R.Constructed of aluminium, the manifoldsare available with 1 to 6 connections and fitted with a 1, 5 or 10 bar pressure gauge according to requirements . Connections are designed for 6mm plastic or copper pipes.

Supplied with one way manifold as standard