Alpha Engineering

Compressed air dryers remove moisture from compressed air systems to protect downstream equipment. When moisture persists in a compressed air system it leads to the formation of scale, rust and bacteria. These contaminants can damage equipment, ruin product batches, and contaminate pharmaceutical or food products. ALPHA ENGINEERING  makes Refrigerated Air Dryer in a combination of an Open loop Air cycle and a closed loop refrigerant cycle. The air here is cooled to very low  temperatures (+3°C)  so as to allow the moisture content in it to condense. The condensed water is removed from the air line thus rendering air free from moisture. Dry Air Keeps Pneumatics equipment running at peak efficiency and extends the service life of air tools, motors & cylinders. Dry air allows pneumatic instruments, valves and controls to operate reliably, and helps ensure product and process quality. 

1. TEC-11:  FOR COMPRESSED AIR FILTERS designed to drain condensate from all compressed air FILTERS regardless of filter capacity. The in-line design allows for fast efficient installation. The TEC-11 can be matched to any model/brand or type of filter. 2. EZ-1:  ECONOMY DRAIN - The EZ-1 is produced with a 1/4" valve connection and in 230 VAC or 115 VAC versions. The limited variations have allowed for massive production batches and subsequently a reduction in cost. The reliability factors have remained in place such as Viton seals, large orifice etc. 3. OPTIMUM:  The Optimum has a wide range of variations and options such as valve connection sizes in both BSP or NTP and pressure/voltage options. The "new futuristic look" allows the OPTIMUM to make its mark well into the new millennium. The OPTIMUM replaces the very familier TEC-22 range. More options are in NICHE products.

dust particles from the compressed air & make it suitable for instruments & process air application. Alpha Filters are designed for high dust load & for continues removal of moisture & oil content. These filters can  remove dust particles down to 0.01micron & can reduce the oil level down to  All filters are made with die-cast aluminum body with powder coating & the elements are made of high quality Glassfibre Material. When used, these filters can give the air quality suitable for even sterile air application.  Our filters and elements are available in six different grades complying to the requirement of the different classes of compressed air quality recommended in the ISO8573-1. Equivalent (Replacment) filters Elements: Alpha makes filter housing with elements of high standard for new projects installation & also Replacements elements for the filters of Ultra filter, Dominick Hunter, parker atlascocp, zander & other world known brands.

Alpha Engineering  offers a full range of both horizontal and vertical air receivers upto 5000 its @ maximum working pressure of 30 kgf/cm². These receivers are manufactured according to IS : 2825/ ASME Sec VIII DivI/EN 286 standards. To Store the Compressed Air Depends on the application, Receiver tanks can be designed as per the  standard 0.05 m³ upto 5 m³ capacities  and the operating pressure upto 40 bar.

1. Baffle Type:  Efficiency 60 % 2. Centrifugal Type:  Efficiency 70% 3. Demister Pad Type:  Efficiency 80% 4. Centrifugal cum Demister Pad Type:  Efficiency 99% Moisture is most common contaminant present and the one which probably causes the most damage.  Alpha Engineering  provides wide range of moistrues separators  for all flows, line sizes, pressure, temperature, flange ratings with an Advanced Moisture Relief System. 

Alpha Engineering  air cooled after coolers consists of a mixed flow finned tube heat exchanger, suitable cooling fan & motor and stand in which compressed air in tubes is cooled to a temperature of 5 to 8°C above ambient temperature. Capabilities upto 300 cfm @ a maximum pressure of 70 kgf/cm² can be offered. Integral moisture separators can also be supplied as optional accessory.