Other Products / Services #361466

Strip wound interlock hose is a high-quality, general purpose hose construct from a single strip of metal that is profiled and interlocked itself. The interlocked section of strips is able to slide back and forth, providing ability to flex.

AMBICAFLEX electrical conduit is line of manufacturing strip wound squarelock hose without packing for using in wire and cable protection. AMBICAFLEX have exclusively manufacture electrical conduit with added strength, added flexibility, highly durability and suitable for movable cables exclusively for electrical wire and cable protection.

TYPE

1. CONTRUCTION MATERIAL:

• a. Electro-galvanized Steel
• b. Stainless Steel 304
• c. Stainless Steel 316

2. APPLICATION:

• As mechanical protection for insulated wires and cables are likely to be exposed to hot and corrosive atmospheric condition
• As shield for fibre optic cables
• As mechanical protection for flexible drive such as flexible shaft grinders and vibrators
• As outer jacket for insulated pipe line
• As a decorative flexible tube for bathroom fittings
• As a protective covering for rubber and plastic hose such as burners, ovens, domestic gas and gas water heaters.

automotive exhaust connector is manufactured from thin wall welded tube. Welded tubes wall is formed electrical conduit is line of manufacturing strip wound squarelock hose without packing for using in wire and cable protection. AMBICAFLEX have exclusively manufacture electrical conduit with added strength, added flexibility, highly durability and suitable for movable cables exclusively for electrical wire and cable protection.For have vibration requirement there is two layers of welded tube is used also for improving exhaust flow connector is designed with inner liner of strip wound hose or wire braided.

AMBICAFLEX automotive exhaust connector is manufactured from thin wall welded tube. Welded tube’s wall is formedin between rolls for corrugation then after external wire braid applied on corrugation tube. It is flexing thought corrugation. For have vibration requirement there is two layers of welded tube is used also for improving exhaust flow connector is designed with inner liner of strip wound hose or wire braided.

1. CONTRUCTION MATERIAL:

• Stainless Steel 304

2. APPLICATION:

• In the exhaust manifold on the cylinder block of motor vehicle
• For provide motion, thermal compensation and isolate vibration of exhaust system
• For adjusting misalignment in exhaust pipeline
• Absorbing vibration and stresses for noise reduction

3. SIZE RANGE:

32MM (1 ¼” Inch) To 100MM (4” Inch)

 

 

automotive exhaust connector is manufactured from thin wall welded tube. Welded tubes wall is formedin between rolls for corrugation then after external wire braid applied on corrugation tube. It is flexing thought corrugation. For have vibration requirement there is two layers of welded tube is used also for improving exhaust flow connector is designed with inner liner of strip wound hose or wire braided.

We are offering strip wound square lock hose.

we are offering exhaust hose pressure

we are offering wire braided

We are offering stainless steel bellows.