MBP BEARINGS Private Limited Delhi

Product Specification A universal joint is a joint or coupling in a rigid rod that allows the rod to 'bend' in any direction, and is commonly used in shafts that transmit rotary motion. It consists of a pair of hinges located close together, oriented at 90° to each other, connected by a cross shaft.

Product specification the inner and outer ring raceways are segments of cones and the rollers are also made with a taper so that the conical surfaces of the raceways and the roller axes if projected, would all meet at a common point on the main axis of the bearing.> this conical geometry is used as it gives a larger contact patch, which permits greater loads to be carried than with spherical (ball) bearings, while the geometry means that the tangential speeds of the surfaces of each of the rollers are the same as their raceways along the whole length of the contact patch and no differential scrubbing occurs. When a roller slides rather than rolls, it can generate wear at the roller-to-race interface, i.e. The differences in surface speeds creates a scrubbing action. Wear will degenerate the close tolerances normally held in the bearing and can lead to other problems. Much closer to pure rolling can be achieved in a tapered roller bearing and this avoids rapid wear.

Product specification self-aligning ball bearings have two rows of balls and a common sphered raceway in the outer ring. The bearings are insensitive to angular misalignment of the shaft relative to the housing. self-aligning ball bearings generate less friction than any other type of rolling bearing, which enables them to run cooler even at high speeds. self-aligning ball bearings are double row, self-retaining units comprising solid outer rings with a concave raceway, inner rings with a cylindrical or tapered bore and ball and cage assemblies. The bearings are available in open and sealed versions.

Product specification cylindrical roller bearings offer excellent resistance to instantaneous overloads and shocks. They simplify assembly thanks to their detachable elements and allow, for certain types, axial displacement or low axial load, for other types. Cages the standard cage for these bearings is the polyamide cage which allows bearing operating temperatures of 120°c or 248°f (150° or 302°f peak). The standard cage for series 4 is in pressed steel. The machined brass cage is available on option. Large-dimension bearings are equipped with a machined brass cage. For special applications in which the synthetic material cage is unacceptable, a metal cage can be provided on request. Capabilities loads and speeds cylindrical roller bearings are designed to withstand radial loads withstand moderate axial loads if the position of the shoulders on the rings allows them accept high speeds of rotation misalignment cylindrical roller bearings accept misalignment of about 0.06° thanks to the correction on the roller surface profile

Product Specification A ball bearing is a type of rolling-element bearing that uses balls to maintain the separation between the bearing races. The purpose of a ball bearing is to reduce rotational friction and support radial and axial loads. It achieves this by using at least two races to contain the balls and transmit the loads through the balls. In most applications, one race is stationary and the other is attached to the rotating assembly (e.g., a hub or shaft). As one of the bearing races rotates it causes the balls to rotate as well. Because the balls are rolling they have a much lower coefficient of friction than if two flat surfaces were sliding against each other. Ball bearings tend to have lower load capacity for their size than other kinds of rolling-element bearings due to the smaller contact area between the balls and races. However, they can tolerate some misalignment of the inner and outer races. MBP use improved ball quality to so to provide noise free bearings and smooth running MBP ball bearings have an optimized surface finish on all the contact surfaces to provide the sufficient lubrications this allows the bearings to run cooler and last longer

Product specification the entire basic steering assembly is called a triple tree, triple clamp, steering head, steering head yoke, or steering stem. Up until around 1985 most, but not all, bikes used loose ball bearings for their steering races. These bearings have upper and lower outer races that are a tight press fit in the frame and a lower inner race that is press fitted to the steering stem. The upper inner race is a loose fit.