silver-filled conductive adhesiveis an epoxy-based conductive adhesive that uses nanosilver filler to generate electrical connections between two components. it is a two-component system. the conductive material is silver.
features
- two-component system
- cost-effective
- superior shielding over a wide frequency range.
- good abrasion resistance
- excellent environmental resistance
general instructions
- to ensure good bonding, surface preparation is required.
- adhesive and activator is to be stirred well prior to use.
- mix thoroughly adhesive and activator in a 1:1 ratio.
- apply a bit of adhesive over the substrates, place mating substrates on the adhesive.
- do not mate substrates over adhesive which is too dry to transfer.
- leave it for 24 hours to cure.
- use enough material to completely fill the gap.
- use with adequate ventilation.
- avoid prolonged contact with skin. if contact with skin occurs, wash the affected area immediately with soap and water.
- avoid prolonged breathing of vapour
- dangerous if swallowed- do not consume.