We are offering los angeles abrasion machine. it is used for determining the resistance to wear of small size coarse aggregates and crushed rock. The machine consists of a hollow cylinder, mounted on a sturdy frame on ball bearings. A detachable shaft which extends throughout the inside length of the drum catches the abrasive charge and does not allow it to fall on the cover. The drum is rotated at a speed of 30-33 rpm by an electric motor through a heavy duty reduction gear. Suitable operation on 415v, 3 phase, 50hz, ac supply. Supplied complete with abrasive charge.

We manufacture and supply Permeability Tester used for permeability test on pozzolana cement mortar with or without water. The equipment consists of brass cells of 100 mm. and 50 mm diameter. Each cell with collar is clamped in between a base plate and a top plate with the help of tension rods and nuts. The cell assembly is mounted on the stand. The top plate is provided with inlet and air release vent and the base plate is provided with an outlet. A pressure chamber is fitted with a pressure regulator and a pressure gauge 0-10 kg/cm2 indicating chamber pressure, and a pressure gauge 0-7 kg/cm2 indicating test pressure. Models AvailablePermeability Apparatus, three cell with foot pumpPermeability Apparatus, Six cell with an end pressure gaugeFeaturesDurableResistance to rustEasy to controlCost-effectiveSafeLow maintenance

We manufacture Concrete Permeability Tester through which high pressure permeability test can be conducted on different size specimens using different cells. Each cell is made of steel and provided with a top plate and funnel at the bottom having gasket seals held in position through bolts and nuts. The concrete specimens are sealed in cell to prevent along the size walls. The permeated water is collected in glass bottles attached at the bottom. Each test stall has its own control system, operating pressure gauges and valves. In Concrete Permeability Tester, all tests can be performed at the same time using either the same head or varying head pressure as each stall is provided with its own pressure regulator and control. The control instruments are mounted on a sturdy welded structural stand. All multi-units are provided with end pressure gauges. Each unit is provided with chamber pressure gauges of 0-20 kg/cm2 and test pressure gauges of 0-15 Kg / cm2. Used inCivil engineeringSoil testing laboratoriesConstruction companiesFeaturesDurableResistance to rustEasy to controlCost-effectiveLow maintenance

We are a name of repute in manufacturing and supplying Load Frames of superior quality at reasonable rates. The Load Frames we export are available in two models. LOAD FRAME MOTORISED CAPACITY 50KN HAVING 8 SPEEDSFeaturesTwo Pillar typeDetachable FrameEnclosed Motor and Gear SystemIndicatorSpeed ChartUseful in Triaxial and C.B.R. testComponentsCabinet which housed the electrical motorReduction gear the loading is done by the upward movement of the lower plate which is firmly fixed to the lead screw. When the lever is set in the neutral position , it isolate the lead screw from the rest of the drive mechanism, and the lead screw ca n then be manually moved up or down by operating the handle.A main switch, an indicator and a forward reverse switch are fixed on the unit.A relay is fitted inside the cabinets that in case of power failure, the unit will not restart of its own on the resumption of power, unless the switches are operatedThe adjustable cross head can be set at any desired position or height over the two pillars and secured in position by tightening the adjustment nut. It has a hexagonal adaptor.Its rates of strain are 0.0 2 5mm. /min, 0 .0 5mm/min , 0 .0 5mm/min , 0.0 6 2 5 , 0 .1 2 5mm/min , 0 .0 2 5mm. /min , 0 . 0 2 5mm. /min , 0 . 5mm/min, 0 . 6 2 5mm. /min and 1.2 5mm. /min.Suitable forOperation on 230 volts, 5 0 cycles , single phase , A.C. supplyLOAD FRAME MOTORIZED CAPACITY 50KN WITH 3 RATES OF STRAIN.Technical detailsTwo pillar typeDetectable frameEnclosed motor and gear systemIndicatorUseful tri-axial and C.B.R testElectrical motorReduction gearAdjustable crossheadMain switch, forward reverse and reverse switch fixed on the unitRelay is fitted for power back-upHexagonal proving ring adaptorRate of strain are 2 .5mm./min, 1.5mm/min and 1.2 5mm. /minUsed inConstruction industryChemical industrySoil-testing purpose