Our Products
C | Si | Mn | P | S | Cr | Cu | Ni |
≤ 12 | 0.25 - 0.75 | 0.20 - 0.50 | 0.07 - 0.15 | ≤ 0.030 | 0.50 - 1.25 | 25 - 0.55 | = 0.65 |
Yield Strength (MPa) |
Tensile Strength (MPa) |
Minimum Elongation A (Lo = 5.65 vSo) % |
355 | 470 - 630 | 20 |
Yield Strength (MPa) |
Tensile Strength (MPa) |
Minimum Elongation A % |
275 | 410 | 25 |
Champak Industries range of Steel Plate- GRADE C45, TISCRAL is widely known for its quenching and tempering ability. This kind of steel is widely used various industries for general engineering purposes. This range is designed to withstand tremendous amount of weights and pressure. This steel plate is rust proof in their make and it has been made using the best technology available in the market and they have been priced at very reasonable rates in the market.
C45 EN 10083-2 Number:1.0503 |
Comparisons of steel grades | |
---|---|---|
JIS G 4051 | S 45 C | |
DIN 17200 | C 45 | |
NFA 33-101 | AF65-C 45 | |
UNI 7846 | C 45 | |
BS 970 | 070 M 46 | |
UNE 36011 | C 45 k | |
SAE J 403-AISI | 1042/1045 |
Grade | C(%)min-max | Si(%)min-max | Mn(%)min-max | P(%)max | S(%)max | Cr(%)min-max |
---|---|---|---|---|---|---|
C45 | 0.42-0.50 | 0.15-0.35 | 0.50-0.80 | 0.025 | 0.025 | 0.20-0.40 |
Grade | Condition | Yield Strength R°(Mpa) |
Tensile Strength Rm (Mpa) |
Elon- gation A5(%) |
Hardness HRC |
Quenching Temperature (℃) |
Benda- bility |
Nominal Thickness,t 1.95mm≤t≤10.0mm |
|||||||||||||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Rolled | Annealed | ||||||||||||||||||||||||||||||||||||||||||||
C45 | Rolled Annealed Water-quenched Oil quenched |
460 330 |
750 540 2270 1980 |
18 30 |
58 55 |
820 860 |
Min.reco-mmended Bending radius (≤90°) |
2.0 ×t |
1.0×t
EN C45 steel Chemical Composition
|
Champak Industries is a large stock of shipbuilding steel plate. This is normally used for shipbuilding and offshore use. We keen on supporting customers' requirements of thicker and higher quality plates especially when through thickness testing is important.
Mainly our steel plates for shipbuilding are approved by either Lloyds Register of Shipping (LRS) or Det Norske Veritas (DNV).
We can also support customers who require shipbuilding plates to ABS though this comes as an additional report to the MTC