HAIYANG CITY ENFEE PACKING CO LTD.

haiyang, China

Introduction:

Mirror Safety Film W280/W300 is one kind of strong polyethylene film coated with special acrylic pressure sensitive adhesive. It is specially designed to pass category I mirror shatter-proofing specifications on both vision and film sides. It can offer a tight bond to mirror back paints, provide an optimum performance, durability and safety to humans. when the mirrors are broken, there are no shatters all around.

Specifications:

1. Description: safety film for mirror backing, 130microns thickness, clear color.

2. Material: pure PE film coated with high performance acrylic adhesive.

Backing: PE Film

Adhesive: high performance acrylic adhesive

3. Item No.: W280/W300

4. Total thickness: 80microns, 100microns, 130micorns, 260microns, other thickness can be made as your requirement.

5.Size: 815mmx200m, 915mmx200m, 1235mmx200m, other roll size can be made by your requirement.

6. Color: clear, white, black and white, black, etc.

7. Paper Core: 3inch

Technical data:

1.Adhesion: 5N/25mm

2. Tack9# Steel Ball

3. Cohesion72hours

4. Tensile Strength: 25MPa

5. Elongation at break: 500%.

6. Impact StrengthA method250g

7. Product shelf life is 18 months from date of manufacture under normal conditions of 70 and 50% relative humidity.

Benefits:

Specially designed to pass category I shatter-proofing test, so that it can meet the human safety requirement.

It is perfect for use on a safety backing or silver float glass mirrors or back painted float glass.

High performance acrylic adhesive provides a superior adhesion to mirror backing paints.

Meets requirements of American National standard ANSI Z97.1-1984

Application Instructions

It is suitable to all kinds of safety backing or silver float glass mirrors or back painted float glasses. The films can perform well while using the machines to apply the films; no air bubbles or winkles adhere to the paint of mirrors well.

The physical properties listed above are average values and are not to be construed as specifications. Our suggestions and recommendations for use are based on tests we believe to be reliable. However, the purchaser must determine the suitability of the product for their intended use. Enfee assumes no liability for claims beyond the replacement value of our product proved to be defective.

This is a very low-adhesion film used as a secondary material to improve yield in film and foil processing. It has excellent dimensional stability and causes no heat-shrinkage damage to the adherent product even in high-temperature environments. It also has strong chemical resistance.

Excellent dimensional stability in heating processes and a design that minimizes curling.

No adhesive deposit on the adherent product.

Silicon-free release film, so there is no risk of contamination.

Also has excellent chemical resistance and anti-scratch properties.

Can be easily peeled off after use thanks to its light-peel design.

Helps prevent wrinkles and folds in processing and improves production yield.

Protective films for preventing film/foil curling, wrinkling and foreign-matter adhesion while undergoing heating.

Carrier film for printed circuit board and flexible printed circuit board processes

(*a)180C 40kg/cm230 min., (*b)150C 30min.

The above values are typical but not standard values.

Please inquire separately about thicknesses.

We also manufacture a double-sided type for uses that require it.

Protective Film for Wood is a LDPE product for surface protection on wood panel.Ideal for wood protection and requires no moisture, heat or special preparation prior to application, and can be used immediately after application.

Temporary protection is for up to 45 days.

SUGGESTED FOR:

Clean, Stain-Free, One-Piece Removal even after 45 day application.